Reference: 148.6008
Kit 75cc Ø48mm POLINI Reproduction 6000 series aluminum for SACHS
The POLINI 6000 series kit reproduced for enthusiasts! For 39.6mm stroke.
Banner
A full set of rare performance parts for old motorcycles engine SACHS long stroke RS 503 and 504. This cylinder made of high quality aluminum straight out of molds made in Italy! It has 4 large intake transfers with internal lubrication system to the cylinder and in line with its piston. The architecture and finish are excellent course and upscale. A huge exhaust with bar charts and high engine make this group a powerful asset to your 2 wheels! The piston accompanying this cylinder is a two-segment in VERTEX therefore high quality model. With segments L will offer you the couple. It is also delivered with his head over compress thus allow you to best exploit your engine on and off all nine. Clearly, a quality / price / excellent performance to give your life SACHS.
We recommend to accompany this kit with at least a 17mm carburetor, racing cold plug, engine oil 100% synthetic racing, reinforced crankshaft and bearings, exhaust racing ....
This pack contains:
Aluminum master cylinder 4 transfers with exhaust with bar
-piston VERTEX two-segment
-2 Segments L Ø48mm X 1mm chrome steel
Axis-Ø12 piston
Piston -Clips G
-pack Engine seals
-Notice
-Autocollant
Optional we offer a preparation course 1, this preparation is a modification of the channels and the exhaust port by increasing the charts and improvement of the duct, it increases the cylinder performance. Improved piston and bottom skirt is also included in the amendment. Allow a little extra time for this preparation!
Reference: 148.6008
The POLINI 6000 series kit reproduced for enthusiasts! For 39.6mm stroke.
Reference: 53488.00
A high performance high-end motor special race 44mm for Minarelli P6! Fixing the exhaust with 3 screws, for RADIAL SYSTEM.
Reference: 64432.00
A complete high-performance high-end engine special for SACHS 503 and 504 with a 14mm axle with 2 transfers with a long stroke crankshaft.
Reference: 85306.00
The piston-cylinder without cylinder head 70cc for ZUNDAPP air cooling for miniterm engines.
Reference: 074000/1
Very good 70cc kit for SACHS integrated cylinder head! Available with or without intake pipe.
Reference: 021700
The cylinder kit, piston, cylinder head, Ø48mm ATHENA for P4R, MACAL, MALAGUTI FIFTY ....
Reference: 85307.00
A 70cc kit for ZUNDAPP air cooling for miniterm engines.
Reference: 64445.00
A high-performance and full high special range for motor SACHS 503 and 504 in axis of 12mm with 4 transfers with a short stroke crankshaft.
Reference: 54272.00
Piston cylinder for FBM engine, FBM for FABRICA BOLOGNESE MOTOCICLI was the association of MINARELLI and MORINI!
Reference: 30122.00
Kit very torquey, robust and powerful for GUZZI DINGO 50cc 2T.
Reference: 003800
80cc kit of very high quality, complete with valves and pipe for motorization MORINI era!
Reference: 073800
The most powerful kit on the market for SACHS has cylinder head connected to the cylinder! Full version with clamshells!
Reference: 012002435
A complete set of quality. Guaranteed performance!
Reference: 003100
Very torquey, robust and powerful kit for ZUNDAPP!
Reference: 85207.00
The complete kit 70cc for ZUNDAPP with its cylinder head!
Reference: 25104.00
PARMAKIT 80cc special kit for old FANTIC CABALLERO. 48X48mm studs.