Reference: 247766
Inlet valves DOPPLER ER2 fiberglass for casings origin peugeot 103
Valves mounted in mono-lamelle fiberglass for your 103.
Banner
Ideal for mounting your flexible carburettors from 15 to 21mm PHBG or CP, this intake pipe is the most efficient on the market for Peugeot 103, it is extremely short and well venturized / studied.
Made in 3D printing by powder sintering. This process makes it possible to offer an optimum shape of the intake ducts.
Inventory of the different parts:
- 1 pipe
- 4 screws (number identical to the fixing point)
- 4 washers (number identical to the fixing point)
-1 sleeve
WARNING: the material used is sensitive to tightening, it is imperative not to exceed the tightening torque (4Nm), and not to forget to use the washers provided. In the case of incomplete sealing, favor the use of the joint bracket, rather than excessive tightening of the screws which would cause deformation of the sole.
Assembly :
1) Coat the contact surface of the joint surface of the CAF type joint bracket
2) Place the washers and screws provided, then screw until contact.
3) Tighten the screws to 4Nm
Reference: 247766
Valves mounted in mono-lamelle fiberglass for your 103.
Reference: 365117
Valves mounted in mono-slat carbon 0.35mm for your 103!
Reference: 293370
A quality sleeve that absorbs vibrations very well for better gas flow.
Reference: 215.0370
Intake pipe for POLINI support housings incorporated on PEUGEOT 103.
Reference: 02 2083B
The top of the intake pipe to put your PHBG 17.5mm to 21mm on your 103.
Reference: 1403
A pipe which will be perfect accompanied by a carburettor PHBG 19 to 21mm. This pipe is blasted with a good finish to avoid the rebound of gases.
Reference: 1399
Ideal in case of breakage or wear of your old part.
Reference: 1400
An amazing pipe with a very good finish that will agree very well with a carburetor 18 to 21mm.
Reference: 365641
A shorter pipe for better venturi effect. This pipe is the highest end of the market. It will be perfect with a carburetor 19 to 21mm.
Reference: PIP07
Intake pipe for carburetor in flexible assembly from 15 to 21mm.
Reference: 2017588
Special pipe for peugeot 103 vogue, ideal in combination of a carburetor of 15mm SHA and a valve sport!
Reference: 56251.05
Ideal with a carburettor PHBG 19 to 24mm and achieve maximum performance! Model "finned" for mob Peugeot 103 SPX, RCX ...
Reference: 02 6489B
A pipe specially designed for flexible assemblies. This pipe was specially created for the competition. It is therefore mounted with a flexible PHBG carburetor from 15 to 21mm.
Reference: 02 6487B
The best to accompany a 15 or 16mm SHA carburetor on your 103!
Reference: 02 5035B
The best to repair or modify the size of your MALOSSI valve boxes on your PEUGEOT 103 or MBK 51.
Reference: 02 1690B
An intake pipe adapted for a carburettor of 15mm or 16mm SHA on PEUGEOT 103!
Reference: 215.0308
The replacement pipe for valves boxes POLINI on PEUGEOT 103 SP, MV, LM ...
Reference: 1402
An intake pipe with a good finish that will allow you to mount your carburetor Ø14 to 16mm while gaining power.