Reference: 215.0227
POLINI intake pipe Ø20mm by 24mm (PHBG) Peugeot 103 SPX, RCX, CLIP, MVX
High quality intake pipe for mounting PHBG carburetors from 17.5 to 21mm.
Banner
Inlet pipe for valve box Peugeot 103 sp, mv, mvl, lm ... POLINI only. Aluminum, fixing system screw + washer X3. Delivered naked. We will regratterons that it is not microbillée to avoid rebounds of gas, however the finish is at the top.
2 models available :
Pipe d.15mm for SHA carburettor
Pipe d.19mm for carburettors PHBG
Reference: 215.0227
High quality intake pipe for mounting PHBG carburetors from 17.5 to 21mm.
Reference: PIP07
Intake pipe for carburetor in flexible assembly from 15 to 21mm.
Reference: CAL02RRD
RRD PERFORMANCES wedge for re-orientation and adaptation of MINARELLI AM6 / DERBI valves / pipe on PEUGEOT 103 engine with POLINI housings, with built-in brackets.
Reference: 928.270.006
POLINI pipe for THOR engine or adaptation on PEUGEOT 103 / MBK 51 requiring an elbow admission!
Reference: 215.0225
Very good POLINI intake pipe for fitting 17.5 to 21mm PHBG carburettors.
Reference: 02 2083B
The top of the intake pipe to put your PHBG 17.5mm to 21mm on your 103.
Reference: 496075
Ideal in case of breakage or wear your old room.
Reference: 365641
A shorter pipe for better venturi effect. This pipe is the highest end of the market. It will be perfect with a carburetor 19 to 21mm.
Reference: 02 6488B
A pipe that mounts very well with a PHBG from 17.5 to 21mm. This pipe is corrected and revised for better distribution.
Reference: 02 5035B
The best to repair or modify the size of your MALOSSI valve boxes on your PEUGEOT 103 or MBK 51.
Reference: 02 1690B
An intake pipe adapted for a carburettor of 15mm or 16mm SHA on PEUGEOT 103!
Reference: 144.270.001
Flexible polini pipe 21mm for mini-moto and cross 2T POLINI, or mounting on POLINI crankcases with PEUGEOT 103 and MBK 51 supports!
Reference: 1399
Ideal in case of breakage or wear of your old part.
Reference: 215.0226
Intake pipe ideal for fitting SHA 15 or 16mm carburettors.
Reference: 1402
An intake pipe with a good finish that will allow you to mount your carburetor Ø14 to 16mm while gaining power.
Reference: 02 6238B
A pipe specially designed for MALOSSI housings. It is very short with good diffusion, micro-blasted and with horizontal bars to avoid any gas rebounds. Clearly a very well worked pipe which will be accompanied by a VL6 valve box or other AM6 valve and a 21mm carburetor.