Cylinder / piston without cylinder head 70cc Ø47mm cast BARIKIT scooter KYMCO Dink, dink Grand, Super9 ...

Attention parts only reserved for the competition, prohibited on road!

Here is the 70cc cast in BARIKIT Ø47mm. This cylinder head without good price does not neglect the quality or performance .. Cast iron, it has 5 transfers of admission and an oval exhaust. Also available complete with his head.



Charts are pretty high at admission and low enough to escape making the torquey and not difficult to follow or set. The piston is a two-segment model! Clearly this kit has a very good ratio torque / power, it offers plenty of performance while preserving a great strength!



The piston is bi-model segments with segments purposes, steel, arched. It has a light preparation on the rear apron to improve scanning and filling of admission. The finish is good.



The cylinder head is a high compression, hemispherical model, polished finish. This kit will certainly be less effective than MALOSSI MHR, BIDALOT or Polini ... But there will already very good.



We recommend to accompany this kit with: carburation 19mm (carbon flaps slats 0.30mm) drive racing, crankshaft and reinforced bearings, exhaust racing, candle racing ...

The pack contains:

X1 cylinder 7 transfers cast
X1 Piston dual segments with preparation rear skirt
X2 Segments, purpose, steel, curved 1.2mm thick
X1 Piston pin Ø12mm X 40mm
X2 piston Clips G

Optional we offer a preparation course 1, this preparation is a modification of the channels and the exhaust port by increasing the charts and improvement of the duct, it increases the cylinder performance. Improved piston and bottom skirt is also included in the amendment. Allow a little extra time for this preparation!

Itself on:

KYMCO Dink
KYMCO Grand Dink
KYMCO Super9

KYMCO Bet & Win

And many other models ...