Reference: 685
housings seal motor origin or original type TEKNIX Peugeot 103
A seal of high quality at low cost for safe motor and leakage!
PEUGEOT 103
MBK 51
MOTOBECANE
PIAGGIO CIAO / VELOFAX
PEUGEOT FOX
HONDA CAMINO, PX, PXR...
DERBI VARIANT
SOLEX
PUCH
MINARELLI AM6
Low-pass exhaust pipe
High-pass exhaust pipe
DERBI Euro 3 / 4 / 5
DERBI Euro 1 & 2
MINARELLI P4 & P6
MINARELLI RV6, RV5, RV4, RV3
SUZUKI SMX, RMX, TSX
YAMAHA TY, RD, DT, MX
HONDA MB, MT, MTX, MBX, NSR R
YAMAHA CHAPPYBanner
Here is an economical part but yet of good quality! This set of housings is really complete and all for a reasonable price ...

Ideal to start afresh and / or to do a good engine preparation on a clean base, especially since this set of housings is very thick and leaves room for machining!


Contains :
-1 spy plate for the drive side with its screws.
-2 screws for the plate
-1 set of 4 studs
-1 complete set of screws
-1 complete set of washers
-1 complete set of nuts

Mounts on:
All PEUGEOT 103 models
Reference: 685
A seal of high quality at low cost for safe motor and leakage!
Reference: 56209.50
Housings adapted for the 77cc Ø50mm kit for 103.
Reference: 170.0020
The bare version without bearings, spy joints or studs, all the same delivered with pipe, valves ...
Reference: CMG4
Competition engine casings for HYBRID and COMPETITION engines on MBK 51, PEUGEOT 103...
Reference: 57 5208
The must of the crankcase for 103, a very powerful design, an unequaled quality!
Reference: usinage-54mm-carter
Machining for passage of Ø50mm cylinders on MBK 51, PEUGEOT 103, ...
Reference: 170.0080
Very well known housings in the middle of the 103 because very well worked and finished for a price that has earlier affordably seen the quality of the housings.
Reference: 170.0050
Known and renowned housings from POLINI. This pack is renowned and above all complete which allows a considerable financial advantage.
Reference: 170.0090
The famous big casings for SPX / RCX / MVX and CLIP, version without bearings, neither joints spy, nor studs!
Reference: 57 4275
Carter MALOSSI MG2 and MG3 for Peugeot 103
Reference: CMG2B 103
Competition engine casings for PEUGEOT 103 with PEUGEOT G2 engine base
Reference: 32020640
Engine housings with a very good quality / price ratio. Ideal for a total refurbishment of your PEUGEOT 103.
Reference: CARTER-HYB
Competition engine casings for HYBRID and COMPETITION engines on MBK 51, PEUGEOT 103...
Reference: 56204.50
High-end casings, ideal for advanced engine preparation!
Reference: 57 6548
Super performing housings, which allow to pass the admissions of motorcycle DERBI and MINARELLI AM6 on your PEUGEOT 103, quality at the top! Built-in support!
Reference: 170.0010
The excellent small POLINI housings for 103!
Reference: 170.0060
Large crankcases with large intake and support in "bare" version for your 103!