Reference: 1400
CGN intake pipe with seal and screw Ø19mm by 24mm (PHBG) Peugeot 103 sp, mv, mvl, lm ...
An amazing pipe with a very good finish that will agree very well with a carburetor 18 to 21mm.
Banner
Here is the MALOSSI pipe of 20mm for Peugeot 103 SPX / RCX / MVX and CLIP, also arises on VOGUE which require a fairly long assembly. This intake pipe is a model specially designed for flexible mounting. It is a label version because it is specially machined and was used for group 1 (with PHBG 15mm) and 2 (with PHBG 19mm) competitions.
The fixing diameter is therefore 23mm, you can put a flexible sleeve there with a flexible PHBG carburetor with a diameter of 19 to 21mm recommended (malossi also mounted the 15mm with this pipe). The finish is good, it is worked at the level of the duct to obtain a good venturi effect. It has a lateral location for the installation of a lung or other after making a thread.
Reference: 1400
An amazing pipe with a very good finish that will agree very well with a carburetor 18 to 21mm.
Reference: 1402
An intake pipe with a good finish that will allow you to mount your carburetor Ø14 to 16mm while gaining power.
Reference: 2017588
Special pipe for peugeot 103 vogue, ideal in combination of a carburetor of 15mm SHA and a valve sport!
Reference: CAL02RRD
RRD PERFORMANCES wedge for re-orientation and adaptation of MINARELLI AM6 / DERBI valves / pipe on PEUGEOT 103 engine with POLINI housings, with built-in brackets.
Reference: 1399
Ideal in case of breakage or wear of your old part.
Reference: 215.0226
Intake pipe ideal for fitting SHA 15 or 16mm carburettors.
Reference: 215.0227
High quality intake pipe for mounting PHBG carburetors from 17.5 to 21mm.
Reference: 496075
Ideal in case of breakage or wear your old room.
Reference: 1314916B
Ø32mm spare sleeve angled at 90 ° internal for MALOSSI admission kit on VESPA 80, 125, 200 ...
Reference: 02 5035B
The best to repair or modify the size of your MALOSSI valve boxes on your PEUGEOT 103 or MBK 51.
Reference: 365641
A shorter pipe for better venturi effect. This pipe is the highest end of the market. It will be perfect with a carburetor 19 to 21mm.
Reference: 02 6488B
A pipe that mounts very well with a PHBG from 17.5 to 21mm. This pipe is corrected and revised for better distribution.
Reference: 02 6487B
The best to accompany a 15 or 16mm SHA carburetor on your 103!
Reference: 02 2083B
The top of the intake pipe to put your PHBG 17.5mm to 21mm on your 103.
Reference: 02 6238B
A pipe specially designed for MALOSSI housings. It is very short with good diffusion, micro-blasted and with horizontal bars to avoid any gas rebounds. Clearly a very well worked pipe which will be accompanied by a VL6 valve box or other AM6 valve and a 21mm carburetor.