Reference: 9919270
intake pipe Ø24mm TOP PERFORMANCES TPR for minarelli am6
Pipe replacement inlet diameter 24mm carburettor MIKUNI TM24 or other flexible mount models.
Banner
Here the flexible pipe + adapter for rigid TUN 'R carburetor for mécaboite minarelli am6. It will guide your carburetor slightly to the left and down, very convenient to most of the am6 equipped. It works as an outlet for separated greasing depression or even lung, you can also block this decision without any problem.
It comes with an aluminum ring that serves to ask the female carburetor (HARD) or other types PHBG diameter fixing 24mm, inner diameter of 19mm aluminum parts. If you have a male carburettor (flexible, which enters the pipe) not use this ring, the pipe is provided for a male-type carburetor PHBL, VHST, PHBH ... fixing diameter 29 / 33mm carburetor diameter 24 28mm.
Installation Summary:
With aluminum ring: for rigid carburettor PHBG female ... in 19 to 21mm
Without ring aluminum: for carburettor-type male PHBL, PHBH, VHST ... 24 to 28mm
It is of excellent design, taking great vibration is very short, and the output is well distributed ... Being fully rubber gasket no need, they are integrated in the pipe, it leads in some cases heat , avoid all rebounds of gases, and it comes with necklace and a steel support for tightening in any reinforcement.
Reference: 9919270
Pipe replacement inlet diameter 24mm carburettor MIKUNI TM24 or other flexible mount models.
Reference: 215.0439
Special intake pipe for POLINI CP 23 and 24mm carburetors. 360 ° swivel with 40 ° tilt angle.
Reference: 075705
A very well designed intake pipe, ideal for accompanying a high engine configuration.
Reference: 25526
A quality aluminum pipe to replace the old one.
Reference: 215.0463
For an improved admission and a gain in performance! Adjustable 360 ° with tilt angle at 20 °.
Reference: 53405.05
Pipe of admission ideal to accompany a carburetor 17.5mm to 21mm!
Reference: 590
A pipe that will increase performance while spending little.
Reference: 524153
An original type BETA RR intake pipe, ideal for am6 center distance assemblies that require an angled intake pipe!
Reference: 317.0005
Set of 2 M6 studs that can be used for many applications.
Reference: 10870
A pipe with a correct finish which will allow you to mount your carburetors from 19 to 26mm.
Reference: 0211199B
21mm pipe for HONDA MB, MT, MTX 50 / MINARELLI AM6 50 ...
Reference: 2013800
The high-end and ultra-efficient Viton version!
Reference: 9931740
TPR intake kit, 360 ° swivel, flexible assembly specially designed to accompany an OKO, PWK POLINI, FURYTECH, KEIHIN ... 24 to 28mm carburetor on AM6 & DERBI Ø34mm mounting.
Reference: 2013801
A very high-end special for large carburations on MINARELLI AM6, DERBI ...
Reference: 9906940
Ideal to accompany the carburetors 19 to 21mm on your mécaboite minarelli am6.
Reference: 269801
A pipe that will gain in performance while spending little.