Reference: 075705
ATHENA racing intake pipe for motorcycle 50cc MINARELLI AM6 Ø19 to 28mm with flexible Ø23mm adapter
A very well designed intake pipe, ideal for accompanying a high engine configuration.
Banner
The flexible pipe brand ATHENA racing for all minarelli am6. It will send your carburetor slightly to the left and down, very convenient to most of the am6 equipped. It works as an outlet for separated greasing depression or even lung, you can also block this decision without any problem.
It comes with an aluminum ring which is used to ask the female phbg carburetor or other type of fastener diameter 24mm, inner diameter of 19mm aluminum parts.
If you have a male carburettor (which enters the pipe) not use this ring, the pipe is provided for a carburetor-type male phbl ... fixing diameter 29 / 33mm carburetor diameter 24 to 28mm.
Installation Summary:
With ring aluminum: for carburettor female phbg ... in 19 to 21mm
Without ring aluminum: for carburettor-type male phbl, PHBH, TM24 ... 24 to 28mm
It is of excellent design, taking great vibration is very short, and the output is diffusee ... Being fully rubber gasket no need, they are integrated in the pipe, it leads in some cases heat , avoid all rebounds of gases, and it comes with necklace and a steel support for tightening in any reinforcement.
Reference: 075705
A very well designed intake pipe, ideal for accompanying a high engine configuration.
Reference: CT00746
A good quality pipe with an almost perfect finish for a more than affordable price!
Reference: 02 6639B
An intake pipe designed for large carburetion This pipe is short for faster recovery.
Reference: 512119
A very well designed intake pipe, ideal to accompany a high engine configuration.
Reference: 2013800
The high-end and ultra-efficient Viton version!
Reference: 467799
The unbeatable quality / price / practicality ratio for your am6 engines!
Reference: 9906940
Ideal to accompany the carburetors 19 to 21mm on your mécaboite minarelli am6.
Reference: 215.0427
For an improved admission and a gain in performance! Adjustable 360 ° with tilt angle at 20 °.
Reference: 075705
A very well designed intake pipe, ideal for accompanying a high engine configuration.
Reference: 53405.05
Pipe of admission ideal to accompany a carburetor 17.5mm to 21mm!
Reference: 494635
Optimize the performance of your mécaboite!
Reference: 9919270
Pipe replacement inlet diameter 24mm carburettor MIKUNI TM24 or other flexible mount models.
Reference: 215.0397
Pipe of admission Ø19mm, ideal for laying a rigid 21mm PHBG 17.5 has a motorcycle that requires a bent pipe as the Aprilia RX, MX 50 ...
Reference: 1773
A quality 360 ° swivel pipe to replace the old one Supplied with two 30 and 45 ° sleeves!
Reference: 25526
A quality aluminum pipe to replace the old one.
Reference: 0211199B
21mm pipe for HONDA MB, MT, MTX 50 / MINARELLI AM6 50 ...
Reference: 9929240
Replacement for TPR orientable intake pipes with MIKUNI TM 24 and OKO 28 carburettor on mécaboite Minarelli AM6 and DERBI.