Reference: S.1447 - 001447 (PIAGGIO)
PIAGGIO cylinder head nut or distance M7X100 thread length 29mm for Peugeot 103 / MBK 51 / AM6 / DERBI…
Ideal in case of breakage, loss or worn thread of your old nut.
Banner
Here is an alignment game, this little game helps improve performance. For example on a Peugeot 103 / fox / wallaroo cylinder, there is a large thread to allow you to fit an exhaust with Ø32mm thread. If you install a flanged exhaust (2 fixing screws) the exhaust or the ball joint will not be aligned at all ... You will therefore install this Malossi alignment game. This game will allow a good alignment, but also no loss and that the gases go to the right place. The set is complete, it includes the ring and the gasket.
Reference: S.1447 - 001447 (PIAGGIO)
Ideal in case of breakage, loss or worn thread of your old nut.
Reference: 15202529
Ideal for aligning your pot to your cylinder to avoid loss of power.
Reference: 8803
Reinforced cable clamp Ø8mm X L.1,3cm for cable diameter Ø3,5mm.
Reference: 19 6313Q
The strongest studs in the range, withstand extreme tightening torques. Amply support 25nm (2.25 mkg)!
Reference: 311.0000
POLINI cylinder head connector universal 14x1.5.
Reference: 031152
Original PEUGEOT copper decompression gasket for your PEUGEOT 103 cylinder head!
Reference: 19 4725
Very long and reinforced, these nuts allow tightening with more precision and withstand a higher tightening torque!
Reference: 66 4696.J0
Ideal for having more precise assemblies.
Reference: 87307000
Ideal in case of breakage, loss or worn thread of your old nut.
Reference: 87171100
Ideal in case of breakage, loss or worn thread of your old nut.
Reference: préparation_sur_mesure
Tailor-made preparation on request.
Reference: rrd-cale-9mm-103
Special 10mm shim for long stroke crankshafts / RRD long connecting rods on PEUGEOT 103.
Reference: 707712
An original stud from PEUGEOT ideal in case of breakage or wear of your old stud. Maximum tightening 16nm or 1,63mk / g.
Reference: 504674
Ideal for aligning your pot with your cylinder to avoid power losses.
Reference: usinage_culasse_sur_mesure
Custom machining of a cylinder head.
Reference: ESP.07.125.4
The strongest with MALOSSI, specially lengthened for high engines with wedges for stroke or long connecting rod, withstand extreme tightening torques. Amply support 25nm (2.25 mkg)!