
Reference: 11700118
BIDALOT centering pin / needles for cylinder / cylinder head
2 pawns to improve your assembly of your kit, casing, cylinder head...
Banner
Here is the ALGI cable clamp, CGN selection for PEUGEOT decompressors, MBK rear brake or other uses. Ideal for a refurbishment, it is of good quality! Attention, the price concerns only one piece, sold individually.
Characteristics:
-Diameter of the cable clamp: Ø6mm
-Length total: 1cm
-Diameter cable passage: Ø2,5mm
Reference: 11700118
2 pawns to improve your assembly of your kit, casing, cylinder head...
Reference: rrd-cale-9mm-103-parmakit
Special 9mm shim for large PARMAKIT Ø50mm air or liquid transfer cylinders with long stroke crankshafts / long RRD connecting rods on PEUGEOT 103.
Reference: 19 6313Q
The strongest studs in the range, withstand extreme tightening torques. Amply support 25nm (2.25 mkg)!
Reference: 87181000
Ideal in case of breakage, loss or worn thread of your old nut.
Reference: rrd-cale-1mm-103
1mm shim in high quality machined aluminum for PEUGEOT 103, FOX, HONDA WALLAROO. Ideal for posing long races to increase your diagrams!
Reference: 87171100
Ideal in case of breakage, loss or worn thread of your old nut.
Reference: 472434
Ideal for redoing a cylinder in the event of primer, heating or simply to remove micro-scratches that hold the oil.
Reference: 210170
Nut true unity origin Peugeot for many applications.
Reference: 15202529
Ideal for aligning your pot to your cylinder to avoid loss of power.
Reference: 9178
Ideal in case of renovation of your engine and strongly recommended to change the top engine of your 2 wheels.
Reference: 8814 / 821000
Convenient washers for a game-free setup.
Reference: 87175000
Ideal in case of breakage, loss or worn thread of your old nut.
Reference: 167905
Copper decompressor gasket for your PEUGEOT 103 cylinder head!
Reference: 167916
A set of reinforced and treated P2R cylinder head nuts for quality maintenance of your high engines.
Reference: 485343
A reinforced stud from CGN, ideal in case of breakage or wear of your old stud. Maximum tightening 16nm or 1.63mk / g.
Reference: ESP.07.125.4
The strongest with MALOSSI, specially lengthened for high engines with wedges for stroke or long connecting rod, withstand extreme tightening torques. Amply support 25nm (2.25 mkg)!