Not approved on the road, cylinder not respecting the displacement of 50cc!
Here is a very good aluminum kit for HONDA MB 50cc, MT 50cc and NSR 50cc air cooling. A true top-of-the-range Made In Italy. The cylinder is therefore an aluminum model with a high quality nikasil coating. The channels, the finish ... everything is excellent!
Equipped with 6 transfers including 2 on each side and 3 at the back specific. Its admission is widened and optimized to improve filling. A very powerful kit! With its diameter of 44.5mm, it still offers 70cc and will combine maximum torque & strength!
The piston is a high-end model. The latter is equipped with two openings on the rear in order to promote filling / sweeping at the level of your admission, its fixing center distance for the manifold / intake pipe is 61 X 40mm. It delivered to you with a jet of carburettor of 98 in order to exploit at best the performances of the cylinder
Accompanied by 2 segments in chromed steel 1.5mm thick, reinforced clips type G and Ø12mm axle. high revs (top speed)! A real gem from MALOSSI.
The pack contains:
-Cylinder aluminum Ø44,5mm
-Piston reinforced Ø44.5mm with preparation on the rear skirt
-2 steel segments, chromed 1.5mm thick
-Pack joint-Instructions, delivered of use
- Stickers
Installs on motorcycles:
-HONDA MB 5 (speed) 50
-HONDA MT 5 (speed) 50
-HONDA MTX (automatic) 50
-HONDA MTX 5 (speed) 50
-HONDA NSR (automatic) 50
As an option we offer a stage 1 preparation, this preparation is a modification of the channels and the exhaust port by increasing the diagrams and improving the duct, it increases the performance of the cylinder. An improvement to the piston and the bottom of the skirt is also included in this modification. Allow a little extra time for this preparation!
.png)
.png)
