Reference: 1399
Pipe of admission CGN Ø15mm by 19mm (SHA) Peugeot 103 sp, mv, mvl, lm ...
Ideal in case of breakage or wear of your old part.
Banner
There are 29 products.
Active filters
Reference: 1399
Ideal in case of breakage or wear of your old part.
Reference: 144.270.001
Flexible polini pipe 21mm for mini-moto and cross 2T POLINI, or mounting on POLINI crankcases with PEUGEOT 103 and MBK 51 supports!
Reference: 215.0226
Intake pipe ideal for fitting SHA 15 or 16mm carburettors.
Reference: 215.0225
Very good POLINI intake pipe for fitting 17.5 to 21mm PHBG carburettors.
Reference: 215.0227
High quality intake pipe for mounting PHBG carburetors from 17.5 to 21mm.
Reference: 215.0370
Intake pipe for POLINI support housings incorporated on PEUGEOT 103.
Reference: 02 2083B
The top of the intake pipe to put your PHBG 17.5mm to 21mm on your 103.
Reference: 365641
A shorter pipe for better venturi effect. This pipe is the highest end of the market. It will be perfect with a carburetor 19 to 21mm.
Reference: CAL02RRD
RRD PERFORMANCES wedge for re-orientation and adaptation of MINARELLI AM6 / DERBI valves / pipe on PEUGEOT 103 engine with POLINI housings, with built-in brackets.
Reference: 1400
An amazing pipe with a very good finish that will agree very well with a carburetor 18 to 21mm.
Reference: 215.0308
The replacement pipe for valves boxes POLINI on PEUGEOT 103 SP, MV, LM ...
Reference: 02 5035B
The best to repair or modify the size of your MALOSSI valve boxes on your PEUGEOT 103 or MBK 51.
Reference: 02 6488B
A pipe that mounts very well with a PHBG from 17.5 to 21mm. This pipe is corrected and revised for better distribution.
Reference: 02 6487B
The best to accompany a 15 or 16mm SHA carburetor on your 103!
Reference: 02 1690B
An intake pipe adapted for a carburettor of 15mm or 16mm SHA on PEUGEOT 103!
Reference: 02 6238B
A pipe specially designed for MALOSSI housings. It is very short with good diffusion, micro-blasted and with horizontal bars to avoid any gas rebounds. Clearly a very well worked pipe which will be accompanied by a VL6 valve box or other AM6 valve and a 21mm carburetor.
Reference: 02 6489B
A pipe specially designed for flexible assemblies. This pipe was specially created for the competition. It is therefore mounted with a flexible PHBG carburetor from 15 to 21mm.
Reference: 1314916B
Ø32mm spare sleeve angled at 90 ° internal for MALOSSI admission kit on VESPA 80, 125, 200 ...
Reference: 1402
An intake pipe with a good finish that will allow you to mount your carburetor Ø14 to 16mm while gaining power.
Reference: 1403
A pipe which will be perfect accompanied by a carburettor PHBG 19 to 21mm. This pipe is blasted with a good finish to avoid the rebound of gases.