Complete air cooling motor delivered assembled and ready to roll! We have equipped this engine with crankcases POLINI, a reinforced crankshaft DOPPLER ENDURANCE.
*For mounting on a chassis for AV7 high fastening, use this adapter!
For intake / carburation: valves POLINI racing with carbon fiber slats attached to the engine, flexible Ø21mm pipe for mounting PHBG (you can put a PHBG RIGIDE carburettor and remove the pipe from the pack if desired).
For the ignition part, we install a MVT PREMIUM (analogue with small internal rotor variation). For the High Engine, we chose the POLINI 46mm W with STAGE 2 preparation, set to the base mounted on cap MVT 46mm inward plot, diagrams clearly enhanced to get higher diets!
The engine comes without spark plug, in the basic configuration, we recommend a B9HS for setting and running, then a B10HS.
Drive engine 500km. Use 100% quality synthetic oil at 2.5% in SP98 or SP100. To be installed with exhaust MVT S-RACE. Think of using a quality belt in good condition! (not provided)
A stage 2 engine preparation is available (option in the cylinder).
Only reserved for competition !!
Possible speed with good acceleration: 105 to 125km/h depending on transmission.
Target diet: Around 10 500 rpm with preparation STAGE 2
Gets on:
MBK 51.
Delivered:
-Without dimmer (you can add a dimmer to the cart, we refuse to install the original type dimmer first price, it will be to be installed by you). We recommend at least one DOPPLER ER2 with clutch pulley DOPPLER ER2 for the better!
-No motor spring, spring DOPPLER with yellow spring strongly recommended!!!
-No candle (B10HS and B9HS recommended)
.png)
.png)
