Reference: 213.0012
POLINI competition valves for scooter VESPA ET3, ETS, SPECIAL ... PIAGGIO APE 50, 125cc
High-end valves complete with slats. To be assembled in the pipes admission kits with POLINI valves from VESPA, APE ...
Banner
With a lot of study and designed in the best materials, here is the monolamelle system on the intake manifold Ø24mm POLINI for scooter VESPA. Of course of high quality, it removes all the disadvantages of the original admission. It can be fitted with original crankcases and crankshaft with a carburation of 16 to 24mm. For more power, POLINI recommends crankcase preparation to optimize reliability and performance. Comes complete as presented.
In download link, a PDF 100% complete technical diagram and advises using this admission.
Mounts on scooter:
-VESPA: VESPA 50 PK - VESPA 50 XL - VESPA 125 PK - VESPA 125 XL ...
POLINI strongly advises after 200 km of use to carry out a serious and general control of the assembly of this admission. To check the tightening and locking against the housing. All this due to the increase in power caused by this piece of competition.
Reference: 213.0012
High-end valves complete with slats. To be assembled in the pipes admission kits with POLINI valves from VESPA, APE ...
Reference: 215.0116
Inlet kit with single-flap valves! Gain of torque and very high power in relation to a mounting without valves. For carburetor of origin or CP 19 and 21mm rigid special or flexible standard.
Reference: 215.0163
For an improved admission with carburettor POLINI CP 24mm flexible mounting, fixing by 3 holes!
Reference: 215.0232
Ideal to pass on a system has flaps and thus to gain in couple, power and consomation! To accompany a 17,5mm POLINI CP special for the best!
Reference: 215.0002
Pipe for small carburetors rigid or large carburetors flexible assembly!
Reference: 215.0272
The best way to mount a big PWK carburetor on your PIAGGIO APE by gaining performance!
Reference: 20 4709
Inlet pipe for MALOSSI carburettors or other soft mountings on your VESPA scooter.
Reference: 02 4957B
Ideal to improve and optimize the performance of your scooter VESPA 50 and 125cc.
Reference: 215.0205
For improved intake (to pass over valve system) with carburettor POLINI CP or other flexible mounting in Ø22 to 26mm, fixing by 2 holes as the origin.
Reference: 215.0162
Ideal for improving and optimizing the performance of your VESPA scooter.
Reference: 215.0233
For an improved admission with carburettor POLINI CP 24mm, fixing by 3 holes! High performances guaranteed!
Reference: 215.0231
Unique and efficient design, POLINI mono-lamella system for VESPA scooter in diameter 19mm for POLINI or original carburetor with 3 fixing holes.
Reference: 215.0113
Valve inlet pipe for special kit POLINI 140.0051 / L.
Reference: 1610843
A pre-adjusted MALOSSI carburettor kit delivered ready to be mounted on a pipe with flexible Ø37mm sleeve on vespa PK 50cc 2T.
Reference: 215.0271
Valve inlet kit for increased performance, pipe fitting Ø 23mm.
Reference: 11251700
Replacement aluminum intake sleeve for your VESPA!
Reference: 215.0112
Valve inlet pipe for special kit POLINI 140.0051 / L.