Pipe C. BOUCHET PHBG or CP 15 to 21mm flexible mounting for MBK CRAZY BIKE

Attention it is delivered without seal, to pose with paste ATHENA ATHESIL! Hey! Couple lock with a dynamometer tool mandatory (about 4.5nm recommended)!

Competition intake pipe C. BOUCHET printed in 3D in a specific material resistant very well to heat! This pipe allows the installation of carburetors POLINI CP 15 to 21mm or DELLORTO PHBG 15 to 21mm. The pipe, designed by a motorist, is obviously designed for maximum performance. It comes with a flexible oil resistant anti-vibration sleeve, its two collars and its screws! A beautiful piece, indispensable for the big engine configurations of MBK CRAZY BIKE! An advantage of flexible mounting and 3D printing is the thermal cut-off between the carburettor and the engine to heat the gas mixture in the carburettor. Ideal on CRAZYBIKE since this machine only has little way to change performance level (specific pitch, fixed motor without dimmer...).

We decided not to sell the RIGIDE version, having already a lot of wear problems on rigid aluminum pipes mounted with SHAs, we prefer not to market the 3D printed version that risks settlement and therefore a carburettor that starts to turn on itself after some clamps that have not been done perfectly in the rules.

*The installation of carburettors from 15 to 17.5mm although possible, is not recommended, the pipe is designed to lay from 19 to 21mm!