Reference: 150837
Crankshaft, connecting rod assembly ARTEK K2 EVO 40mm stroke for mécaboite driving DERBI euro 3 & 4
The most performance crankshaft from ARTEK which can go up to 18,000 revolutions!
Banner
A competition crankshaft from PARMAKIT RACING for motorcycle DERBI Euro 3 and 4. This crankshaft is in original race (40.00mm) with an original connecting rod size 90mm. Thanks to its extra large connecting rod, its increased crank pin and its ultra reinforced cages, this crankshaft will withstand your most efficient kits without worry. The connecting rod was mounted on anti-friction wedges. The lubrication has also been revised as much as possible. Thanks to its full masses, it will increase your pre-compression and therefore performance. It has a keying to facilitate the installation of the ignition. The balancing is very good (balancing marks by internal machining). The masses are cut from a high-end steel like all PARMAKIT crankshafts.
Reference: 150837
The most performance crankshaft from ARTEK which can go up to 18,000 revolutions!
Reference: 518746
High performance crankshaft, 18,000 rpm, forged connecting rod, ground with heat treatment.
Reference: CB.12.9R
The ULTIMATE vilo for DERBI EURO 3 and 4, large 20mm spans, forged mass machined rod, excellent balancing, .... The best of the best !!!
Reference: 12101386
High-end reinforced FACTORY crankshaft ideal to accompany a prepared engine configuration!
Reference: CIG-79R
A high quality crankshaft, ideal for strengthening your low engine while preserving an original 40mm stroke!
Reference: 31085950
An ideal quality crankshaft to strengthen its low engine at a good price!
Reference: 090705B
A good crankshaft at a low price which will hold very well on small 70cc for example.
Reference: 090936C
An ultra reinforced and perfectly balanced crankshaft for DERBI Euro 3 and 4. Ideal for large configurations.
Reference: CIG-129R
A high quality crankshaft, ideal for strengthening your low engine while preserving an original 40mm stroke!
Reference: 080015
Ideal for repairing your low engine and supporting an original configuration or small 50 & 70cc kits.
Reference: 19883
A reinforced crankshaft at a low price but very well balanced. Ideal for small 70cc or 50cc kit.
Reference: 9930150
Excellent vilo delivered with its bearings and spy joints for EURO 3 and 4 engines.
Reference: CIG-60
A very good quality crankshaft that will support 50cc & 70cc kits without problems.
Reference: 468210
One of the best quality / price ratios on the market for your 50 DERBI euro 3 and 4 motorcycle.
Reference: 486140
A crankshaft super reinforced in full masses, solid and of excellent quality with a low price! Ideal to accompany an original configuration or slightly prepared on mécaboite driving Derbi euro 3 and 4.
Reference: 5312990
Top of the range ideal for a pushed engine configuration!