Banner
Ideal for aligning your pot to your cylinder to avoid loss of power.
ATTENTION last piece available !!
Here is the BIDALOT exhaust ring, also called alignment spacer.
This model is machined from high-end aluminum mass. This small part is used to align the ball joint 2 screws (with flange) with the exhaust on the cylinders which have a thread.
It therefore allows you to find a good duct and effect (see exhaust venturi).
Mounts on:
Peugeot 103 / Fox / wallaroo
Reference: 87307000
Ideal in case of breakage, loss or worn thread of your old nut.
Reference: 87171100
Ideal in case of breakage, loss or worn thread of your old nut.
Reference: rrd-cale-9mm-103
Special 10mm shim for long stroke crankshafts / RRD long connecting rods on PEUGEOT 103.
Reference: 172332
Reinforced cable clamp Ø7mm X L.10mm for cable diameter Ø2,5mm.
Reference: 19 6313Q
The strongest studs in the range, withstand extreme tightening torques. Amply support 25nm (2.25 mkg)!
Reference: préparation_sur_mesure
Tailor-made preparation on request.
Reference: 504674
Ideal for aligning your pot with your cylinder to avoid power losses.
Reference: 00002.87
Set of 4 M7 nuts with their 4 washers.
Reference: rrd-cale-1mm-103-parmakit
1mm wedge in high quality machined aluminum for PARMAKIT large transfer cylinders of PEUGEOT 103, FOX, HONDA WALLAROO. Ideal for laying down long runs to increase your charts!
Reference: S.1447 - 001447 (PIAGGIO)
Ideal in case of breakage, loss or worn thread of your old nut.
Reference: 87175000
Ideal in case of breakage, loss or worn thread of your old nut.
Reference: 07 1928B
Special 8mm shim for long stroke crankshafts / long connecting rods RRD or MALOSSI on PEUGEOT 103.
Reference: 167917
A set of reinforced and treated M6 P2R cylinder head nuts to maintain the quality of your high engines.
Reference: 8691
Complete system at a good price and of very good quality. Ideal for a refurbishment of your high engine!
Reference: 311.0000
POLINI cylinder head connector universal 14x1.5.
Reference: 20 6938
For safe power gain at a low price.
Ideal for aligning your pot to your cylinder to avoid loss of power.
