Reference: 53036_00
40mm 90 ° angled tube kit for DELLORTO carburettor
Ideal in case of loss or change the passage of your cable.
Banner
There are 52 products.
Active filters
Reference: 53036_00
Ideal in case of loss or change the passage of your cable.
Reference: 1285
Ideal in case of leakage for a good quality repair at low price.
Reference: 10431
The bowl bottom also called anti-emulsion washer ... Indispensable for the proper functioning of your carburetor and oil / gasoline mixing!
Reference: 213458
A necessary part for the proper functioning of your carburetor.
Reference: 09538_00
Ideal to pass your choke cable pull or to repair your PHBG!
Reference: 1297
A small spring that is important. Ideal for lost or worn for a refurbishment cost.
Reference: 09812
A mass-machined brass cap for your carburetors with aluminum tank or racing black edition!
Reference: 1280
Ideal for refurbishment or for loss.
Reference: 53024
The complete richness screw for your PHBG carburettors!
Reference: 09811_00
The aluminum racing tank, mounts on all PHBG carburettors, to remove your jets faster, drain faster and get more strength!
Reference: 1282
Ideal for lost or just for a refurbishment without spending too much.
Reference: 09444_00
The replacement tank at low prices for your DELLORTO carburettors.
Reference: 30 3339
A quality transparent tank with plug for PHBG and PHBD carburettor.
Reference: 1263
The tension adjuster which is placed at the end of your tubes.
Reference: 09506
Bar, axle, float holding rod for DELLORTO carb.
Reference: 10 5397B
Ideal in case of wear, breakage ... of your old MALOSSI tank cap.
Reference: 1298
The little room in which hangs the starter cable.
Reference: 53027_00
The idle screw with its spring for your PHBG carburettors!
Reference: 01476_00
The original cap of all DELLORTO carburetor. Perfect for any loss or breakage of your old cap.
Reference: 473464
A very aesthetic tank delivered with its seal and screws for a very good price!
Reference: 09596_00
Ideal in case of loss or breakage.