Reference: 10 5397B
Cap for MALOSSI transparent PHBG tank with seal
Ideal in case of wear, breakage ... of your old MALOSSI tank cap.
Banner
Here is the spring of the pilot screw on carburettor DELLORTO PHBG, PHM .... Ideal for refurbishing after loss or wear that little spring that is required for proper operation and adjustment on your carburetor (this spring allows the support of the O-ring seal, and the continued tension screws for not to lose). Has sold the unit.
Internal diameter of the spring: 4mm
External diameter of the spring: 6mm
Spring length: 11mm maximum uncompressed and compressed 5,10mm
Reference: 10 5397B
Ideal in case of wear, breakage ... of your old MALOSSI tank cap.
Reference: 9482
The replacement cover for your DELLORTO PHBG carburetors except racing black edition.
Reference: 129514
For a refurbishment at a lower cost for a perfect seal.
Reference: 129517
The only wealth screws for your PHBG!
Reference: 4477.62
The ring which seals and tightens your intake pipes with your RIGID PHBG!
Reference: 09814_00
A tulip which increases the venturi effect and therefore the efficiency of your engine. In addition to this, you need to know more about it.
Reference: 1263
The tension adjuster which is placed at the end of your tubes.
Reference: 18951-53
The replacement cover for your DELLORTO PHBG carburettors, to screw.
Reference: 53016_00 / B53016B
Kit of complete collar for rigid carburettor PHBG and SHBC!
Reference: 26 4189
Ideal for lost or modify the passage of your cable.
Reference: AP8106790
A tulip that increases the venturi effect therefore the performance of your engine.
Reference: 01104_00
Arises directly in the plug cover, also available in angled with adjuster.
Reference: 1298
The little room in which hangs the starter cable.
Reference: 09450
The replacement float for your carbs, ideal in the event of a fuel leak!
Reference: 09812
A mass-machined brass cap for your carburetors with aluminum tank or racing black edition!
Reference: 09506
Bar, axle, float holding rod for DELLORTO carb.