
Reference: 121692
Locking nut (against nut) for DELLORTO cable tensioning screw
The counter nut that locks your cable tension adjuster on DELLORTO carburettor.
Banner
Ideal for refurbishment after pronounced wear, loss, ... Here is the accelerator / choke cable tensioner screw for DELLORTO carburettor. It is fixed on the tube and requires the locking nut. Delivered alone, unitary.
Total length: 23mm
Thread length 15mm
External diameter of the thread: around 4.90mm
Internal diameter (cable passage) 3mm
Sleeve fitting diameter: 6.90mm
Reference: 121692
The counter nut that locks your cable tension adjuster on DELLORTO carburettor.
Reference: AP8106790
A tulip that increases the venturi effect therefore the performance of your engine.
Reference: 09814_00
A tulip which increases the venturi effect and therefore the efficiency of your engine. In addition to this, you need to know more about it.
Reference: 263991
A complete kit that will allow you to pass your cables as you wish.
Reference: 213458
A necessary part for the proper functioning of your carburetor.
Reference: 10431
The bowl bottom also called anti-emulsion washer ... Indispensable for the proper functioning of your carburetor and oil / gasoline mixing!
Reference: 52526_77
Ideal for refurbishing your standard PHBG or racing black edition.
Reference: 01104_00
Arises directly in the plug cover, also available in angled with adjuster.
Reference: 1282
Ideal for lost or just for a refurbishment without spending too much.
Reference: 53036_00
Ideal in case of loss or change the passage of your cable.
Reference: 493928
A very aesthetic tank delivered with its seal and screws for a very good price!
Reference: 53024
The complete richness screw for your PHBG carburettors!
Reference: 02838_00
Ideal in case of problem, breakage or loss of your old part!
Reference: 09506
Bar, axle, float holding rod for DELLORTO carb.
Reference: 203.1504
A machined / blue anodized part POLINI for your PHBG carburettors!
Reference: 1285
Ideal in case of leakage for a good quality repair at low price.
Reference: 53002-78
A pack to switch your PHBG carburettors choke lever to cable choke!
The tension adjuster which is placed at the end of your tubes.