- -25%
Reference: 215.0330
Inlet pipe for POLINI casings without support incorporated on Peugeot 103 (Ø 15 or 19mm with the choices)
Banner
A pipe specially designed for MALOSSI housings. It is very short with good diffusion, micro-blasted and with horizontal bars to avoid any gas rebounds. Clearly a very well worked pipe which will be accompanied by a VL6 valve box or other AM6 valve and a 21mm carburetor.
MALOSSI intake pipe with internal diameter 20.8mm and external 24mm, for MALOSSI Peugeot 103 casings regardless of the model. Very good design because in aluminum, very short, well diffused, micro-blasting and horizontal bars at the outlet in order to avoid any gas rebounds. It tightened to adapt with original valves VL6 MALOSSI or any valves of MINARELLI am6 which go without problem on these casings.
Know that if you want to put a carburetor bigger than 21mm or even an admission in male carburetor and flexible female pipe, you can put in place of this pipe, certain pipe of MINARELLI am6 of any male or female diameter aluminum or rubber.
Reference: pack_pipe_malossi_AM6_DERBI_90°
MALOSSI pipe for adaptation on PEUGEOT 103 / MBK 51 requiring an angled admission! Center distance am6 / DERBI
Reference: 1314916B
Ø32mm spare sleeve angled at 90 ° internal for MALOSSI admission kit on VESPA 80, 125, 200 ...
Reference: 215.0226
Intake pipe ideal for fitting SHA 15 or 16mm carburettors.
Reference: CAL02RRD
RRD PERFORMANCES wedge for re-orientation and adaptation of MINARELLI AM6 / DERBI valves / pipe on PEUGEOT 103 engine with POLINI housings, with built-in brackets.
Reference: 516867
A shorter pipe for a better venturi effect. It will be perfect with a 19 to 21mm carburettor.
Reference: 365641
A shorter pipe for better venturi effect. This pipe is the highest end of the market. It will be perfect with a carburetor 19 to 21mm.
Reference: 215.0370
Intake pipe for POLINI support housings incorporated on PEUGEOT 103.
Reference: 1403
A pipe which will be perfect accompanied by a carburettor PHBG 19 to 21mm. This pipe is blasted with a good finish to avoid the rebound of gases.
Reference: 20 6138
Ideal to put a carburetor DELLORTO 21 PHBG on your PEUGEOT XP using a system of real valves!
Reference: 02 6488B
A pipe that mounts very well with a PHBG from 17.5 to 21mm. This pipe is corrected and revised for better distribution.
Reference: 02 6489B
A pipe specially designed for flexible assemblies. This pipe was specially created for the competition. It is therefore mounted with a flexible PHBG carburetor from 15 to 21mm.
Reference: 215.0225
Very good POLINI intake pipe for fitting 17.5 to 21mm PHBG carburettors.
Reference: 1399
Ideal in case of breakage or wear of your old part.
Reference: 02 1690B
An intake pipe adapted for a carburettor of 15mm or 16mm SHA on PEUGEOT 103!
Reference: 496075
Ideal in case of breakage or wear your old room.