Reference: 121692
Locking nut (against nut) for DELLORTO cable tensioning screw
The counter nut that locks your cable tension adjuster on DELLORTO carburettor.
Banner
Ideal for refurbishment after pronounced wear, loss, ... Here is the accelerator / choke cable tensioner screw for DELLORTO carburettor. It is fixed on the tube and requires the locking nut. Delivered alone, unitary.
Total length: 23mm
Thread length 15mm
External diameter of the thread: around 4.90mm
Internal diameter (cable passage) 3mm
Sleeve fitting diameter: 6.90mm
Reference: 121692
The counter nut that locks your cable tension adjuster on DELLORTO carburettor.
Reference: 53024
The complete richness screw for your PHBG carburettors!
Reference: 53002_00 / 53002_78
A pack to switch your PHBG carburettors choke lever to cable choke!
Reference: 01476_00
The original cap of all DELLORTO carburetor. Perfect for any loss or breakage of your old cap.
Reference: 09538_00
Ideal to pass your choke cable pull or to repair your PHBG!
Reference: 473464
A very aesthetic tank delivered with its seal and screws for a very good price!
Reference: AP8106790
A tulip that increases the venturi effect therefore the performance of your engine.
Reference: 09812
A mass-machined brass cap for your carburetors with aluminum tank or racing black edition!
Reference: 2707
The idle screw without its spring for your PHBG!
Reference: 4477.62
The ring which seals and tightens your intake pipes with your RIGID PHBG!
Reference: 05 3733B
Ideal to increase the venturi effect so your performance.
Reference: 16962_00
The replacement cover single screw for your carburettors DELLORTO PHBG Racing Red and Black Edition.
Reference: 01104_00
Arises directly in the plug cover, also available in angled with adjuster.
Reference: 4224-82
A tulip which increases the venturi effect therefore the efficiency of your engine.
Reference: 1280
Ideal for refurbishment or for loss.
Reference: 09506
Bar, axle, float holding rod for DELLORTO carb.