
Reference: 52526_77
Complete gasket set for DELLORTO PHBG carburettor
Ideal for refurbishing your standard PHBG or racing black edition.
Banner
Ideal for lost or wear especially that it is a very special screw, only to spring idle screw carburetors PHBG and PHBG racing edition. High quality certified, true DELLORTO.
5mm diameter special thread screws
Length of the complete screw: 30mm
Length of single thread: 15mm
Reference: 52526_77
Ideal for refurbishing your standard PHBG or racing black edition.
Reference: 343.0021
Ideal in case of loss or to pass your cable as desired.
Reference: 09812
A mass-machined brass cap for your carburetors with aluminum tank or racing black edition!
Reference: 09506
Bar, axle, float holding rod for DELLORTO carb.
Reference: 53027_00
The idle screw with its spring for your PHBG carburettors!
Reference: 1282
Ideal for lost or just for a refurbishment without spending too much.
Reference: 09444_00
The replacement tank at low prices for your DELLORTO carburettors.
Reference: 1297
A small spring that is important. Ideal for lost or worn for a refurbishment cost.
Reference: 53031.78
The spare cover with screws for your DELLORTO PHBG carburettors except Racing Red and Black Edition.
Reference: 01476_00
The original cap of all DELLORTO carburetor. Perfect for any loss or breakage of your old cap.
Reference: 30 3338
Ideal for permanent control of your fuel and your settings with ease.
Reference: 121692
The counter nut that locks your cable tension adjuster on DELLORTO carburettor.
Reference: 4224-82
A tulip which increases the venturi effect therefore the efficiency of your engine.
Reference: 16962_00
The replacement cover single screw for your carburettors DELLORTO PHBG Racing Red and Black Edition.
Reference: 09450
The replacement float for your carbs, ideal in the event of a fuel leak!
Reference: 10431
The bowl bottom also called anti-emulsion washer ... Indispensable for the proper functioning of your carburetor and oil / gasoline mixing!
The idle screw without its spring for your PHBG!