Banner
An intake pipe designed for large carburetion This pipe is short for faster recovery.
An intake pipe provided for carburetion big soft climb. For carburetors from 26 to 30mm male as VHST, phbl, PHBH ... diameter mounting 45 to 50mm. This pipe is very interesting for the performance because it is very short and contains an integrated diffuser that allows a good intake valves to.
This diffuser integrates valves will adapt to VL15, VL16, derbi originally polini, malossi mvr / mg .... The pipe is totally right horizontally and carries a downward angle vertically. Its material (rubber) shall know fully absorb the harmful vibrations of admission. The pipe / valve seal is integrated in the intake pipe. In addition, it carries a non-return lip for a good fixation of the carburetor.
You can mount this pipe on minarelli am6, Derbi, motor MG2, MG3 ...
Reference: 9931740
TPR intake kit, 360 ° swivel, flexible assembly specially designed to accompany an OKO, PWK POLINI, FURYTECH, KEIHIN ... 24 to 28mm carburetor on AM6 & DERBI Ø34mm mounting.
Reference: 590
A pipe that will increase performance while spending little.
Reference: 0211199B
21mm pipe for HONDA MB, MT, MTX 50 / MINARELLI AM6 50 ...
Reference: 2013801
A very high-end special for large carburations on MINARELLI AM6, DERBI ...
Reference: 9929240
Replacement for TPR orientable intake pipes with MIKUNI TM 24 and OKO 28 carburettor on mécaboite Minarelli AM6 and DERBI.
Reference: 1773
A quality 360 ° swivel pipe to replace the old one Supplied with two 30 and 45 ° sleeves!
Reference: 317.0005
Set of 2 M6 studs that can be used for many applications.
Reference: 477414
Very good price / quality ratio, ideal to ask a rigid carburettor.
Reference: 487209
A good quality pipe with an almost perfect finish for a price more than affordable!
Reference: LC.44.35
One of the best price / quality ratio for carburetor 28 to 35mm. Reserved for connoisseurs!
Reference: 512119
A very well designed intake pipe, ideal to accompany a high engine configuration.
Reference: 075805
An intake pipe very well designed, ideal to accompany a push engine configuration.
Reference: 215.0397
Pipe of admission Ø19mm, ideal for laying a rigid 21mm PHBG 17.5 has a motorcycle that requires a bent pipe as the Aprilia RX, MX 50 ...
Reference: 215.0427
For an improved admission and a gain in performance! Adjustable 360 ° with tilt angle at 20 °.
Reference: 075705
A very well designed intake pipe, ideal for accompanying a high engine configuration.
Reference: 467799
The unbeatable quality / price / practicality ratio for your am6 engines!
An intake pipe designed for large carburetion This pipe is short for faster recovery.
