Reference: 53024
Complete air richness screw for DELLORTO PHBG carburettors
The complete richness screw for your PHBG carburettors!
Banner
Ideal in case of loss or wear, especially since it is a very special screw, complete idle screw with spring for PHBG and PHBG racing edition carburettors. Certified high quality, genuine DELLORTO .
-External diameter of the spring: 7.20mm
-Spring internal diameter: 5mm
- Spring length: 14mm uncompressed and 6mm compressed at maximum
-Screw diameter 5mm special thread
- Full screw length: 30mm
- Thread length alone: 15mm
Reference: 53024
The complete richness screw for your PHBG carburettors!
Reference: 4477.62
The ring which seals and tightens your intake pipes with your RIGID PHBG!
Reference: 10431
The bowl bottom also called anti-emulsion washer ... Indispensable for the proper functioning of your carburetor and oil / gasoline mixing!
Reference: 09450
The replacement float for your carbs, ideal in the event of a fuel leak!
Reference: 09538_00
Ideal to pass your choke cable pull or to repair your PHBG!
Reference: 129514
For a refurbishment at a lower cost for a perfect seal.
Reference: 09812
A mass-machined brass cap for your carburetors with aluminum tank or racing black edition!
Reference: 1285
Ideal in case of leakage for a good quality repair at low price.
Reference: 9482
The replacement cover for your DELLORTO PHBG carburetors except racing black edition.
Reference: 1282
Ideal for lost or just for a refurbishment without spending too much.
Reference: 09814_00
A tulip which increases the venturi effect and therefore the efficiency of your engine. In addition to this, you need to know more about it.
Reference: 121692
The counter nut that locks your cable tension adjuster on DELLORTO carburettor.
Reference: 02838_00
Ideal in case of problem, breakage or loss of your old part!
Reference: 53031.78
The spare cover with screws for your DELLORTO PHBG carburettors except Racing Red and Black Edition.
Reference: 09779_00
Essential part of your carburettor PHBG for better mixing oil / petrol! Not deep model for jet small step 5mm.
Reference: 09597_00
The valve spring for your carbs, ideal when the handle returns badly or in the event of loss, wear, breakage...