Reference: 10431
Cup bottom of tank on carburettor DELLORTO PHBG and others (small main jet)
The bowl bottom also called anti-emulsion washer ... Indispensable for the proper functioning of your carburetor and oil / gasoline mixing!
Banner
Tank bottom plate (anti-emulsion washer) to jet small step 5mm. Is placed between the needle jet and jet. Despite rumors is said of some, it is by no means a flange. Rather a piece that allows better mixing of the oil / gasoline (when he arrived in the tank), which prevents air bubbles and emulsions ... For DELLORTO carburettors PHBG, PHBG Racing Black / Red Edition Model ... not deep (also available in deep model).
Reference: 10431
The bowl bottom also called anti-emulsion washer ... Indispensable for the proper functioning of your carburetor and oil / gasoline mixing!
Reference: 1282
Ideal for lost or just for a refurbishment without spending too much.
Reference: 53002_00 / 53002_78
A pack to switch your PHBG carburettors choke lever to cable choke!
Reference: 09596_00
Ideal in case of loss or breakage.
Reference: 53024
The complete richness screw for your PHBG carburettors!
Reference: 52526_77
Ideal for refurbishing your standard PHBG or racing black edition.
Reference: 53036_00
Ideal in case of loss or change the passage of your cable.
Reference: 16962_00
The replacement cover single screw for your carburettors DELLORTO PHBG Racing Red and Black Edition.
Reference: 263991
A complete kit that will allow you to pass your cables as you wish.
Reference: 10431
The bowl bottom also called anti-emulsion washer ... Indispensable for the proper functioning of your carburetor and oil / gasoline mixing!
Reference: 1285
Ideal in case of leakage for a good quality repair at low price.
Reference: 4224-82
A tulip which increases the venturi effect therefore the efficiency of your engine.
Reference: 09812
A mass-machined brass cap for your carburetors with aluminum tank or racing black edition!
Reference: 203.1504
A machined / blue anodized part POLINI for your PHBG carburettors!
Reference: 213458
A necessary part for the proper functioning of your carburetor.
Reference: 1263
The tension adjuster which is placed at the end of your tubes.
Reference: 4477.62
The ring which seals and tightens your intake pipes with your RIGID PHBG!