Reference: 129514
Gasket for valve cover for carburettor DELLORTO PHBG
For a refurbishment at a lower cost for a perfect seal.
Banner
A fuel leak is often synonymous with a dead float or a worn needle. The float when it fills with gasoline no longer closes the inlet and the carburetor starts to leak, so it is important to maintain the carburetor and change the float if necessary. This float is the standard 4 gram model.
Reference: 129514
For a refurbishment at a lower cost for a perfect seal.
Reference: 16962_00
The replacement cover single screw for your carburettors DELLORTO PHBG Racing Red and Black Edition.
Reference: 09597_00
The valve spring for your carbs, ideal when the handle returns badly or in the event of loss, wear, breakage...
Reference: 9482
The replacement cover for your DELLORTO PHBG carburetors except racing black edition.
Reference: 121692
The counter nut that locks your cable tension adjuster on DELLORTO carburettor.
Reference: 53036_00
Ideal in case of loss or change the passage of your cable.
Reference: 01104_00
Arises directly in the plug cover, also available in angled with adjuster.
Reference: 473464
A very aesthetic tank delivered with its seal and screws for a very good price!
Reference: 4224-82
A tulip which increases the venturi effect therefore the efficiency of your engine.
Reference: 09812
A mass-machined brass cap for your carburetors with aluminum tank or racing black edition!
Reference: 4477.62
The ring which seals and tightens your intake pipes with your RIGID PHBG!
Reference: 1298
The little room in which hangs the starter cable.
Reference: 343.0021
Ideal in case of loss or to pass your cable as desired.
Reference: 1263
The tension adjuster which is placed at the end of your tubes.
Reference: 10431
The bowl bottom also called anti-emulsion washer ... Indispensable for the proper functioning of your carburetor and oil / gasoline mixing!
Reference: 10 5397B
Ideal in case of wear, breakage ... of your old MALOSSI tank cap.