Reference: 129514
Gasket for valve cover for carburettor DELLORTO PHBG
For a refurbishment at a lower cost for a perfect seal.
Banner
Here is the POLINI inlet tulip machined in the mass of aluminum in anodized blue, signed with the POLINI logo. This tulip improves the venturi effect of your PHBG carburetor. The passage of the tulip has an internal diameter of 28mm up to outlet diameter 50mm. The finish and the angle are perfect! The diameter for installing an air filter is Ø48mm for optimal breathing and filtration.
Characteristics:
Internal diameter 28mm
External outlet diameter 50mm
Air filter fixing diameter 48mm
Reference: 129514
For a refurbishment at a lower cost for a perfect seal.
Reference: 09538_00
Ideal to pass your choke cable pull or to repair your PHBG!
Reference: 53002_00 / 53002_78
A pack to switch your PHBG carburettors choke lever to cable choke!
Reference: 14958_00
Ideal in case of loss or breakage of your old support, bushel socket.
Reference: 02838_00
Ideal in case of problem, breakage or loss of your old part!
Reference: 09444_00
The replacement tank at low prices for your DELLORTO carburettors.
Reference: 09506
Bar, axle, float holding rod for DELLORTO carb.
Reference: 09596_00
Ideal in case of loss or breakage.
Reference: 213458
A necessary part for the proper functioning of your carburetor.
Reference: 52526_77
Ideal for refurbishing your standard PHBG or racing black edition.
Reference: 2707
The idle screw without its spring for your PHBG!
Reference: 1298
The little room in which hangs the starter cable.
Reference: 10 5397B
Ideal in case of wear, breakage ... of your old MALOSSI tank cap.
Reference: 09450
The replacement float for your carbs, ideal in the event of a fuel leak!
Reference: 11540
Excellent in the event of a problem or a leak in your carburetor.
Reference: 10431
The bowl bottom also called anti-emulsion washer ... Indispensable for the proper functioning of your carburetor and oil / gasoline mixing!