
Reference: 09597_00
Valve spring for DELLORTO PHBG and PHBV carburetor
The valve spring for your carbs, ideal when the handle returns badly or in the event of loss, wear, breakage...
Banner
Here is the POLINI inlet tulip machined in the mass of aluminum in anodized blue, signed with the POLINI logo. This tulip improves the venturi effect of your PHBG carburetor. The passage of the tulip has an internal diameter of 28mm up to outlet diameter 50mm. The finish and the angle are perfect! The diameter for installing an air filter is Ø48mm for optimal breathing and filtration.
Characteristics:
Internal diameter 28mm
External outlet diameter 50mm
Air filter fixing diameter 48mm
Reference: 09597_00
The valve spring for your carbs, ideal when the handle returns badly or in the event of loss, wear, breakage...
Reference: 343.0021
Ideal in case of loss or to pass your cable as desired.
Reference: 4224-82
A tulip which increases the venturi effect therefore the efficiency of your engine.
Reference: 121692
The counter nut that locks your cable tension adjuster on DELLORTO carburettor.
Reference: 1263
The tension adjuster which is placed at the end of your tubes.
Reference: 18951-53
The replacement cover for your DELLORTO PHBG carburettors, to screw.
Reference: 1297
A small spring that is important. Ideal for lost or worn for a refurbishment cost.
Reference: 26 4189
Ideal for lost or modify the passage of your cable.
Reference: 53024
The complete richness screw for your PHBG carburettors!
Reference: 1285
Ideal in case of leakage for a good quality repair at low price.
Reference: 53027_00
The idle screw with its spring for your PHBG carburettors!
Reference: 11540
Excellent in the event of a problem or a leak in your carburetor.
Reference: 52526_77
Ideal for refurbishing your standard PHBG or racing black edition.
Reference: 09506
Bar, axle, float holding rod for DELLORTO carb.
Reference: 09450
The replacement float for your carbs, ideal in the event of a fuel leak!
Reference: 10 5397B
Ideal in case of wear, breakage ... of your old MALOSSI tank cap.
A machined / blue anodized part POLINI for your PHBG carburettors!