Reference: 09538_00
Full lever choke lever for carburettor PHBG DELLORTO
Ideal to pass your choke cable pull or to repair your PHBG!
Banner
Complete pipe kit, length 40mm thread off, 90 ° angle. Cable accelerator or choke on carburettor DELLORTO SHA. Mountable on all models DELLORTO standard threading! Delivered as presented with 2 against stop nut, tube, 2 rubbers, 2 threaded tube length adjustment.
Reference: 09538_00
Ideal to pass your choke cable pull or to repair your PHBG!
Reference: 09597_00
The valve spring for your carbs, ideal when the handle returns badly or in the event of loss, wear, breakage...
Reference: 9482
The replacement cover for your DELLORTO PHBG carburetors except racing black edition.
Reference: 09506
Bar, axle, float holding rod for DELLORTO carb.
Reference: 213458
A necessary part for the proper functioning of your carburetor.
Reference: 1263
The tension adjuster which is placed at the end of your tubes.
Reference: 09596_00
Ideal in case of loss or breakage.
Reference: 1282
Ideal for lost or just for a refurbishment without spending too much.
Reference: 30 3338
Ideal for permanent control of your fuel and your settings with ease.
Reference: 1297
A small spring that is important. Ideal for lost or worn for a refurbishment cost.
Reference: 01476_00
The original cap of all DELLORTO carburetor. Perfect for any loss or breakage of your old cap.
Reference: 53027_00
The idle screw with its spring for your PHBG carburettors!
Reference: 53002_00 / 53002_78
A pack to switch your PHBG carburettors choke lever to cable choke!
Reference: 8431
tank gasket for GURTNER carburetor.
Reference: 09812
A mass-machined brass cap for your carburetors with aluminum tank or racing black edition!
Reference: 30 3339
A quality transparent tank with plug for PHBG and PHBD carburettor.