Reference: usinage_culasse_sur_mesure
Custom cylinder head machining (squish, compression rate, etc.)
Custom machining of a cylinder head.
Banner
Ideal for your original cylinder head, MALOSSI, POLINI, BIDALOT or any model, here is the complete TEKNIX decompressor. Good quality at low prices, it is ideal and still available on the market! A very good little product that saves life at hours when mob parts are increasingly rare.
Reference: usinage_culasse_sur_mesure
Custom machining of a cylinder head.
Reference: 9179
Quality stud and reinforced to avoid breakage or wear!
Reference: 317.0103
Reinforced stud of very high quality, very solid in relation to the origin!
Reference: 472434
Ideal for redoing a cylinder in the event of primer, heating or simply to remove micro-scratches that hold the oil.
Reference: 485342
Ideal for fresh start with reinforced studs specific to your engine!
Reference: préparation_sur_mesure
Tailor-made preparation on request.
Reference: 87172000
Ideal in case of breakage, loss or worn thread of your old nut.
Reference: 87175000
Ideal in case of breakage, loss or worn thread of your old nut.
Reference: 486933
Reinforced cable clamp Ø6mm X L.10mm for cable diameter Ø2,5mm.
Reference: 20 6792
Ideal in case of wear or breakage.
Reference: 517937
Very long and reinforced, these nuts allow you to tighten with more precision and support a higher tightening torque!
Reference: 66 4696.J0
Ideal for having more precise assemblies.
Reference: 172332
Reinforced cable clamp Ø7mm X L.10mm for cable diameter Ø2,5mm.
Reference: X4 12512042
Reinforced and elongated nuts to better tighten the cylinder head and more precisely. They can withstand much higher tightening torques!
Reference: 19 4725
Very long and reinforced, these nuts allow tightening with more precision and withstand a higher tightening torque!
Reference: 87170000
Ideal in case of breakage, loss or worn thread of your old nut.