Finally available at us, the racing clutch housing ATHENA competition. It is already raging in enduro competition and speed it is likely to rage this year on the meeting tuning and run!
It allows a straight lightening (1000grammes all round with joints!) But also and especially, a direct and smooth removal of the oil pump, a possibility of retouching the clutch by dismounting the housing in 2 thus via 4 screws (adjustments and changes simpler clutches so ...)!
Its aesthetic is really different from the origin and this carter will bring the rare touch and racing to the most prepared engines! Being reformed, it comes with all the reinforced screws. The name of the brand is molded in 3D in the mass .... Attention, with this case, you can not in any case put an oil pump!
It comes with a kickstop plug, so you can mount it with or without kick. The machining of the half lid is very clean, the liquid journey is reviewed, nothing has been forgotten .... The finish is perfect!
This half housing is mounted on O-ring, the housing is delivered complete with quick plug and clips of cap, O-ring of half crankcase, joint seal of water pump, seal of crankcase, X2 O-ring of which one of tree, X4 half casing stainless steel screws, all crankcase screws, Kicker O-ring ...
.png)
.png)
