Reference: 121692
Locking nut (against nut) for DELLORTO cable tensioning screw
The counter nut that locks your cable tension adjuster on DELLORTO carburettor.
Banner
Adjusting screw and setting accelerator cable without additional trimmer, thread size 19,70mm end Ø6mm surroundings. Thread length 12mm single, true DELLORTO. Ø 6,90mm for the sheath, internal diameter 3.5mm cable crossing. For carburettors DELLORTO. Also available with additional angled adjuster.
Reference: 121692
The counter nut that locks your cable tension adjuster on DELLORTO carburettor.
Reference: 09450
The replacement float for your carbs, ideal in the event of a fuel leak!
Reference: 10 5397B
Ideal in case of wear, breakage ... of your old MALOSSI tank cap.
Reference: 1297
A small spring that is important. Ideal for lost or worn for a refurbishment cost.
Reference: 213458
A necessary part for the proper functioning of your carburetor.
Reference: 16962_00
The replacement cover single screw for your carburettors DELLORTO PHBG Racing Red and Black Edition.
Reference: 10431
The bowl bottom also called anti-emulsion washer ... Indispensable for the proper functioning of your carburetor and oil / gasoline mixing!
Reference: 2707
The idle screw without its spring for your PHBG!
Reference: 493928
A very aesthetic tank delivered with its seal and screws for a very good price!
Reference: 53016_00 / B53016B
Kit of complete collar for rigid carburettor PHBG and SHBC!
Reference: 129517
The only wealth screws for your PHBG!
Reference: 8431
tank gasket for GURTNER carburetor.
Reference: 4477.62
The ring which seals and tightens your intake pipes with your RIGID PHBG!
Reference: 26 4189
Ideal for lost or modify the passage of your cable.
Reference: 09811_00
The aluminum racing tank, mounts on all PHBG carburettors, to remove your jets faster, drain faster and get more strength!
Reference: 09596_00
Ideal in case of loss or breakage.