Reference: 075805
Pipe of admission ATHENA racing for motor bike 50cc MINARELLI AM6 Ø19 with 28mm with flexible Ø24mm adapter
An intake pipe very well designed, ideal to accompany a push engine configuration.
Banner
Here the flexible pipe + adapter for rigid TUN 'R carburetor for mécaboite minarelli am6. It will guide your carburetor slightly to the left and down, very convenient to most of the am6 equipped. It works as an outlet for separated greasing depression or even lung, you can also block this decision without any problem.
It comes with an aluminum ring that serves to ask the female carburetor (HARD) or other types PHBG diameter fixing 24mm, inner diameter of 19mm aluminum parts. If you have a male carburettor (flexible, which enters the pipe) not use this ring, the pipe is provided for a male-type carburetor PHBL, VHST, PHBH ... fixing diameter 29 / 33mm carburetor diameter 24 28mm.
Installation Summary:
With aluminum ring: for rigid carburettor PHBG female ... in 19 to 21mm
Without ring aluminum: for carburettor-type male PHBL, PHBH, VHST ... 24 to 28mm
It is of excellent design, taking great vibration is very short, and the output is well distributed ... Being fully rubber gasket no need, they are integrated in the pipe, it leads in some cases heat , avoid all rebounds of gases, and it comes with necklace and a steel support for tightening in any reinforcement.
Reference: 075805
An intake pipe very well designed, ideal to accompany a push engine configuration.
Reference: 25526
A quality aluminum pipe to replace the old one.
Reference: 512119
A very well designed intake pipe, ideal to accompany a high engine configuration.
Reference: 9929240
Replacement for TPR orientable intake pipes with MIKUNI TM 24 and OKO 28 carburettor on mécaboite Minarelli AM6 and DERBI.
Reference: 215.0439
Special intake pipe for POLINI CP 23 and 24mm carburetors. 360 ° swivel with 40 ° tilt angle.
Reference: 215.0463
For an improved admission and a gain in performance! Adjustable 360 ° with tilt angle at 20 °.
Reference: 317.0005
Set of 2 M6 studs that can be used for many applications.
Reference: 10870
A pipe with a correct finish which will allow you to mount your carburetors from 19 to 26mm.
Reference: 1773
A quality 360 ° swivel pipe to replace the old one Supplied with two 30 and 45 ° sleeves!
Reference: 467799
The unbeatable quality / price / practicality ratio for your am6 engines!
Reference: 9919270
Pipe replacement inlet diameter 24mm carburettor MIKUNI TM24 or other flexible mount models.
Reference: 02 6639B
An intake pipe designed for large carburetion This pipe is short for faster recovery.
Reference: LC.44.35
One of the best price / quality ratio for carburetor 28 to 35mm. Reserved for connoisseurs!
Reference: 590
A pipe that will increase performance while spending little.
Reference: 524153
An original type BETA RR intake pipe, ideal for am6 center distance assemblies that require an angled intake pipe!
Reference: 9931740
TPR intake kit, 360 ° swivel, flexible assembly specially designed to accompany an OKO, PWK POLINI, FURYTECH, KEIHIN ... 24 to 28mm carburetor on AM6 & DERBI Ø34mm mounting.