Reference: 2707
only idle screw for carburettor DELLORTO PHBG
The idle screw without its spring for your PHBG!
Banner
Here is the O-ring of the richness screw on DELLORTO carburettor. Ideal for refurbishment, after loss or wear of this small seal which is necessary for the proper functioning and adjustment of your carburetor. Sold individually as presented.
Mounts on carburettor :
- PHBG / PHBE / PHBH / PHBL / PHF / PHM / VHST ...
Reference: 2707
The idle screw without its spring for your PHBG!
Reference: 30 3339
A quality transparent tank with plug for PHBG and PHBD carburettor.
Reference: 52526_77
Ideal for refurbishing your standard PHBG or racing black edition.
Reference: 8431
tank gasket for GURTNER carburetor.
Reference: 09450
The replacement float for your carbs, ideal in the event of a fuel leak!
Reference: 09814_00
A tulip which increases the venturi effect and therefore the efficiency of your engine. In addition to this, you need to know more about it.
Reference: 11540
Excellent in the event of a problem or a leak in your carburetor.
Reference: 10431
The bowl bottom also called anti-emulsion washer ... Indispensable for the proper functioning of your carburetor and oil / gasoline mixing!
Reference: 09506
Bar, axle, float holding rod for DELLORTO carb.
Reference: 30 3338
Ideal for permanent control of your fuel and your settings with ease.
Reference: 01476_00
The original cap of all DELLORTO carburetor. Perfect for any loss or breakage of your old cap.
Reference: 09444_00
The replacement tank at low prices for your DELLORTO carburettors.
Reference: 10 5397B
Ideal in case of wear, breakage ... of your old MALOSSI tank cap.
Reference: 09811_00
The aluminum racing tank, mounts on all PHBG carburettors, to remove your jets faster, drain faster and get more strength!
Reference: 53031.78
The spare cover with screws for your DELLORTO PHBG carburettors except Racing Red and Black Edition.
Reference: 16962_00
The replacement cover single screw for your carburettors DELLORTO PHBG Racing Red and Black Edition.