Kit carburation MALOSSI Ø32mm PHBE ... for HONDA NS, NSR 125cc RAIDEN ...

Here carburetor kit MALOSSI group. This carburetor is 32mm in diameter PHBE BS. It has nothing to do with a normal carburettor DELLORTO home. It is chosen, adjusted and adapted to ride your HONDA NSR RAIDEN ... 125cc with ease to gain maximum performance possible. Many also go up on the MTX and other 125cc models from HONDA 2T.

 

 

It has a huge round basket, a big bell for better air intake. The settings easily through the tank cap billet aluminum and is easily removable for changing your jet, control and cleaning of the carburetor ...

 

The accessories are precisely machined in aluminum alloys. This carburetor certainly be poorer than a carburetor flat bushel recovery, but it will make you reach very high speeds without any problems! It is becoming more agréble to set up and operate a round bushel daily (less chatter has low speed)! This carburetor has a very good architecture approaching the famous DELLORTO PHBH but significantly improved compared to the past. The needles of the well, the valve cup, etc ... everything has been reviewed for performance and reliability. This model comes with a single fuel inlet, nothing prevents you to change the arrival by a double entry for a better finish. A very large carburetor for assured performance and exceptional quality, this model is very well preset with the material presented below.

 

Technical characteristics:

-Model PHBE 32

Flush flexible type, male-Starter cable (can be with a CPL lever system)

-With Separate lubrication without depression

-Boisseau Round cut 40 ° (degree)

-Size Fixing for air filter: Ø58mm

Fitting mounting -Size intake pipe: Ø39mm (with double anti-slip lips)

-Aiguille Kind K9

-Puit Of needle AB260

Large main -Gicleur not DELLORTO standard 148

-Gicleur Secondary standard DELLORTO small step size 51

Choke -Gicleur 70

-Pointeau CPL 300

X2 Floats amounts 4.0 grams

 

Mounts on HONDA NS, NSR, RAIDEN ... 125cc 2 times.