Reference: 1212275B
MALOSSI exhaust reduction ring from Ø28 to 25mm minarelli am6
Ideal for keeping its exhaust and being able to mount it on this machine.
Banner
Here is a set of 4 ultra-reinforced special size studs + 4 special cylinder head nuts for MALOSSI MHR TEAM 50 and 80cc kits on minarelli am6 engine only! Very high quality, ideal in case of breakage, wear, loss or if you buy a second-hand kit (which are often delivered in these studs and nuts…).
Reference: 1212275B
Ideal for keeping its exhaust and being able to mount it on this machine.
Reference: 156263
Set of 4 M7 nuts with their 4 washers.
Reference: ESP.07.116.4
The strongest with MALOSSI, support extreme tightening torques. Support ample 25nm (2,25 mkg)!
Reference: JAC-01
Base wedge for cylinder, thickness 2.00mm. Machined from the mass of aluminum. Ideal on long stroke 43 and 44mm.
Reference: 167917
A set of reinforced and treated M6 P2R cylinder head nuts to maintain the quality of your high engines.
Reference: 27 8359B
Essential for the refurbishment of your cooling system.
Reference: préparation_sur_mesure
Tailor-made preparation on request.
Reference: 00002.87
Set of 4 M7 nuts with their 4 washers.
Reference: 11700118
2 pawns to improve your assembly of your kit, casing, cylinder head...
Reference: 87170000
Ideal in case of breakage, loss or worn thread of your old nut.
Reference: 87308000
Ideal in case of breakage, loss or worn thread of your old nut.
Reference: 87175000
Ideal in case of breakage, loss or worn thread of your old nut.
Reference: 12512870
Reinforced and treated high-end stud for high engine BIDALOT Racing FACTORY.
Reference: 508303
Cylinder base wedge, thickness 0.5mm. Machined in the mass of aluminum. Ideal for increasing your charts!
Reference: 87307000
Ideal in case of breakage, loss or worn thread of your old nut.
Reference: 437928
A mandatory reduction ring for mounting an exhaust Ø25mm Ø28mm on a cylinder, minarelli am6!