Reference: 4477.62
Reduction ring Ø24mm for DELLORTO PHBG carburettor
The ring which seals and tightens your intake pipes with your RIGID PHBG!
Banner
There are 53 products.
Active filters
Reference: 4477.62
The ring which seals and tightens your intake pipes with your RIGID PHBG!
Reference: 01476_00
The original cap of all DELLORTO carburetor. Perfect for any loss or breakage of your old cap.
Reference: 01104_00
Arises directly in the plug cover, also available in angled with adjuster.
Reference: 05 3733B
Ideal to increase the venturi effect so your performance.
Reference: 09814_00
A tulip which increases the venturi effect and therefore the efficiency of your engine. In addition to this, you need to know more about it.
Reference: 4224-82
A tulip which increases the venturi effect therefore the efficiency of your engine.
Reference: 53016_00 / B53016B
Kit of complete collar for rigid carburettor PHBG and SHBC!
Reference: 30 3338
Ideal for permanent control of your fuel and your settings with ease.
Reference: 263991
A complete kit that will allow you to pass your cables as you wish.
Reference: 129514
For a refurbishment at a lower cost for a perfect seal.
Reference: 1285
Ideal in case of leakage for a good quality repair at low price.
Reference: 1297
A small spring that is important. Ideal for lost or worn for a refurbishment cost.
Reference: 1280
Ideal for refurbishment or for loss.
Reference: 1282
Ideal for lost or just for a refurbishment without spending too much.
Reference: 1263
The tension adjuster which is placed at the end of your tubes.
Reference: 1298
The little room in which hangs the starter cable.
Reference: 473464
A very aesthetic tank delivered with its seal and screws for a very good price!
Reference: 10 5397B
Ideal in case of wear, breakage ... of your old MALOSSI tank cap.
Reference: 30 3339
A quality transparent tank with plug for PHBG and PHBD carburettor.
Reference: 09811_00
The aluminum racing tank, mounts on all PHBG carburettors, to remove your jets faster, drain faster and get more strength!
Reference: 53024
The complete richness screw for your PHBG carburettors!