Reference: 707712
1 pin M7 X 113mm cylinder PEUGEOT for 103 and FOX
An original stud from PEUGEOT ideal in case of breakage or wear of your old stud. Maximum tightening 16nm or 1,63mk / g.
Banner
Set of 4 bolts reinforced with standard M7 thread, length 112.5mm. For cases MALOSSI, POLINI, origin…. From Peugeot 103, Peugeot fox and HONDA wallaroo, minarelli am6, DERBI euro 1 & 2 ... Very high quality! The general tightening recommended on a kit with this type of stud is 18 to 20nm! Consider using a torque wrench. This type of stud can withstand more than 25nm in tightening, the casing threads will give way well before them ...
Reference: 707712
An original stud from PEUGEOT ideal in case of breakage or wear of your old stud. Maximum tightening 16nm or 1,63mk / g.
Reference: 87175000
Ideal in case of breakage, loss or worn thread of your old nut.
Reference: 156263
Set of 4 M7 nuts with their 4 washers.
Reference: 4755
Spare nut essential for mounting your high engine!
Reference: 517937
Very long and reinforced, these nuts allow you to tighten with more precision and support a higher tightening torque!
Reference: S.1447 - 001447 (PIAGGIO)
Ideal in case of breakage, loss or worn thread of your old nut.
Reference: 1443
Ideal in case of breakage of your muffler threads on your cylinders or simply to strengthen your assembly.
Reference: 317.0102
Quality stud and reinforced to prevent breakage or wear. Maximum tightening 18nm or 2,04mk / g. In addition to this, you need to know more about it.
Reference: 66 4696.J0
Ideal for having more precise assemblies.
Reference: 87308000
Ideal in case of breakage, loss or worn thread of your old nut.
Reference: 87172000
Ideal in case of breakage, loss or worn thread of your old nut.
Reference: 20 6938
For safe power gain at a low price.
Reference: 167905
Copper decompressor gasket for your PEUGEOT 103 cylinder head!
Reference: rrd-cale-1mm-103-parmakit
1mm wedge in high quality machined aluminum for PARMAKIT large transfer cylinders of PEUGEOT 103, FOX, HONDA WALLAROO. Ideal for laying down long runs to increase your charts!
Reference: 485343
A reinforced stud from CGN, ideal in case of breakage or wear of your old stud. Maximum tightening 16nm or 1.63mk / g.
Reference: 504674
Ideal for aligning your pot with your cylinder to avoid power losses.