Cylinder / piston without cylinder head 70cc Ø47mm PARMAKIT aluminum for motorcycle SUZUKI 50cc TSX

Attention, not homologated on road, does not respect the cubic capacity 50cc thus only reserved for the competition on circuit.

Here is the kit 70cc diameter 47mm without cylinder head from PARMAKIT for SUZUKI TSX 50cc. This is the most powerful kit on the market for this 50cc bike. High-end aluminum model with nikasil coating and specific treatment, PARMAKIT has placed high diagrams, 6 intake transfers, an oval exhaust.



Its finish is excellent, canals extremely well finished and its architecture very good. Its rear intake is designed to attach a manifold / pipe spacing 41 mm, its output diameter is Ø 21 mm with plug / connector provides.



This cylinder is accompanied by a piston mono-segment of high quality with specific side grease nipples, enough to climb in high speeds without difficulties thanks to the reduction of friction. Obviously not altering its strength and reliability in any event.



Delivered complete with cylinder, piston, axle, clips, segment, pack joints ... We recommend to accompany it with at least a suitable carburation of 19 mm, 100% synthetic racing engine oil, cold racing candle, muffler, bearings and reinforced crankshaft ....

contains:

-Cylinder 70cc Ø47mm aluminum
-Piston mono-segment Ø47mm with lateral grease nipples
-Segment standard steel 47mm X 1.5mm thick
-Axle piston Ø12mm X 40mm
-Clips type crab
-Pack motor gaskets
-Notice
-Autocollant



Optionally we offer a stage 1 preparation, this preparation is a modification of the channels and exhaust light by increasing the diagrams and improving the pipe, it increases the performance of the cylinder. An improvement of the piston and skirt stocking is also included in this modification. Allow a little extra time for this preparation!