Reference: 30 3338
Transparent MALOSSI tank for DELLORTO PHBG and PHBD carburettor
Ideal for permanent control of your fuel and your settings with ease.
Banner
Ideal in case of loss or wear, especially since it is a very special screw, complete idle screw with spring for PHBG and PHBG racing edition carburettors. Certified high quality, genuine DELLORTO .
-External diameter of the spring: 7.20mm
-Spring internal diameter: 5mm
- Spring length: 14mm uncompressed and 6mm compressed at maximum
-Screw diameter 5mm special thread
- Full screw length: 30mm
- Thread length alone: 15mm
Reference: 30 3338
Ideal for permanent control of your fuel and your settings with ease.
Reference: 263991
A complete kit that will allow you to pass your cables as you wish.
Reference: 129514
For a refurbishment at a lower cost for a perfect seal.
Reference: 09506
Bar, axle, float holding rod for DELLORTO carb.
Reference: 53031.78
The spare cover with screws for your DELLORTO PHBG carburettors except Racing Red and Black Edition.
Reference: 09811_00
The aluminum racing tank, mounts on all PHBG carburettors, to remove your jets faster, drain faster and get more strength!
Reference: 1285
Ideal in case of leakage for a good quality repair at low price.
Reference: 18951-53
The replacement cover for your DELLORTO PHBG carburettors, to screw.
Reference: 26 4189
Ideal for lost or modify the passage of your cable.
Reference: 343.0021
Ideal in case of loss or to pass your cable as desired.
Reference: 09538_00
Ideal to pass your choke cable pull or to repair your PHBG!
Reference: 52526_77
Ideal for refurbishing your standard PHBG or racing black edition.
Reference: 4477.62
The ring which seals and tightens your intake pipes with your RIGID PHBG!
Reference: 01104_00
Arises directly in the plug cover, also available in angled with adjuster.
Reference: 4224-82
A tulip which increases the venturi effect therefore the efficiency of your engine.