Reference: 10 5397B
Cap for MALOSSI transparent PHBG tank with seal
Ideal in case of wear, breakage ... of your old MALOSSI tank cap.
Banner
Transparent MALOSSI tank for all PHBG & PHBD carburettors, this tank has a drain and main jet change plug, so you can change your jet in a very short time with a simple flat screwdriver. It is delivered with the cap, the cap O-ring but without tank gasket or tank screws.
Reference: 10 5397B
Ideal in case of wear, breakage ... of your old MALOSSI tank cap.
Reference: 09450
The replacement float for your carbs, ideal in the event of a fuel leak!
Reference: 1298
The little room in which hangs the starter cable.
Reference: 09596_00
Ideal in case of loss or breakage.
Reference: 203.1504
A machined / blue anodized part POLINI for your PHBG carburettors!
Reference: AP8106790
A tulip that increases the venturi effect therefore the performance of your engine.
Reference: 18951-53
The replacement cover for your DELLORTO PHBG carburettors, to screw.
Reference: 09811_00
The aluminum racing tank, mounts on all PHBG carburettors, to remove your jets faster, drain faster and get more strength!
Reference: 506272
Excellent in the event of a problem or leak from your carburetor.
Reference: 213458
A necessary part for the proper functioning of your carburetor.
Reference: 53129_00
Ideal in case of loss or to pass your cable as desired.
Reference: 4477.62
The ring which seals and tightens your intake pipes with your RIGID PHBG!
Reference: 09779_00
Essential part of your carburettor PHBG for better mixing oil / petrol! Not deep model for jet small step 5mm.
Reference: 09506
Bar, axle, float holding rod for DELLORTO carb.
Reference: 16962_00
The replacement cover single screw for your carburettors DELLORTO PHBG Racing Red and Black Edition.
Reference: 9482
The replacement cover for your DELLORTO PHBG carburetors except racing black edition.
Reference: 1282
Ideal for lost or just for a refurbishment without spending too much.