Reference: 1280
carburettor pilot screw spring DELLORTO PHBG, PHM ...
Ideal for refurbishment or for loss.
Banner
If you want to embellish your PHBG with a racing touch while making the jet settings more practical (you just have to remove the cap and tilt the carburetor to change the jet .. Without removing the tank). Here is the machined brass tank cap from Dellorto is reserved for Dellorto PHBG carburettors equipped with aluminum tank. The tank is also on sale here, the cap gasket not being separately, you will have to buy the complete PHBG gasket pack also on sale here.
Reference: 1280
Ideal for refurbishment or for loss.
Reference: 53036_00
Ideal in case of loss or change the passage of your cable.
Reference: 8431
tank gasket for GURTNER carburetor.
Reference: 09506
Bar, axle, float holding rod for DELLORTO carb.
Reference: 01104_00
Arises directly in the plug cover, also available in angled with adjuster.
Reference: 09811_00
The aluminum racing tank, mounts on all PHBG carburettors, to remove your jets faster, drain faster and get more strength!
Reference: AP8106790
A tulip that increases the venturi effect therefore the performance of your engine.
Reference: 493928
A very aesthetic tank delivered with its seal and screws for a very good price!
Reference: 1282
Ideal for lost or just for a refurbishment without spending too much.
Reference: 53016_00 / B53016B
Kit of complete collar for rigid carburettor PHBG and SHBC!
Reference: 1298
The little room in which hangs the starter cable.
Reference: 30 3338
Ideal for permanent control of your fuel and your settings with ease.
Reference: 18951-53
The replacement cover for your DELLORTO PHBG carburettors, to screw.
Reference: 121692
The counter nut that locks your cable tension adjuster on DELLORTO carburettor.
Reference: 203.1504
A machined / blue anodized part POLINI for your PHBG carburettors!