Kit 50cc high engine Ø40mm AIRSAL sports mono-segment aluminum DERBI euro 3

RRD-ID:5964

A much more powerful kit that originally while keeping a very good strength.

More details

manufacturers : AIRSAL
AIRSAL AIRSAL

124,90 € 124.9 tax incl.


Availability: Available directly sending !!!


Here the small kit high AIRSAL 50cc sport for DERBI euro 3. Make a well known good reputation in the community, a very good price / quality ratio.

échappement barrette kit cylindre airsal 50cc derbi euro 3

This model does not have Ø39,9mm diameter (do not hide) extra ordinary performance in comparison to the original because the original cylinder is very good, with aluminum exhaust has booster and a cylinder head stud and better charts than on am6 cast iron, for example. While it will be more efficient because it has a very correct finish, work in the channels that are reviewed and corrected, high compression cylinder head incoming tapered room for proper alignment, an exhaust has bar ...

culasse airsal euro 3 kit 50cc chambre combution

But above all, a good item to start with a good foundation has nine. It is equipped with a piston mono segment to allow more high modes (reduction of frictions). This piston has more lateral nipples. This high engine will therefore offer more performance especially at high rate, a good increase in power and the top speed will be present!

We recommend to accompany this kit with at least: carburetion 19 has 21mm with little preparation of the airbox, exhaust racing, cold candle racing once properly adjusted valves slats 0.35mm.

intérieur cylindre airsal 50cc 39,9mm 40mm derbi euro 3 gpr x-trem x-race

The pack contains:

5 master cylinder intake and exhaust transfers has bar
-piston Ø39,9mm mono 1mm end segment with side grease

Axis-piston of Ø12mm

Piston -Clips G

-pack Of complete joint
-2 Yoke fittings

-Culasse Has incoming high compression chamber
-Notice
-Segment Ø39,9mm by 1mm

kit airsal 50cc mono segment vitesse puissance couple derbi sm enduro


Optional we offer a preparation course 1, this preparation is a modification of the channels and the exhaust port by increasing the charts and improvement of the duct, it increases the cylinder performance. Improved piston and bottom skirt is also included in the amendment. Allow a little extra time for this preparation!

No customer comments for the moment.

Only registered users can post a new comment.

26 other products in the same category:

Previous
Next

Search

Cart  

No products

Shipping 0,00 €
Total 0,00 €

Prices are tax included

Cart Check out

Categories

Pay with credit card

CMCIC3_payment

Manufacturers



Original design by Radius design modified by
By ChapodepaY