Reference: usinage_culasse_sur_mesure
Custom cylinder head machining (squish, compression rate, etc.)
Custom machining of a cylinder head.
Banner
Here is the ALGI cable clamp, CGN selection for PEUGEOT decompressors, MBK rear brake or other uses. Ideal for a refurbishment, it is of good quality! Attention, the price concerns only one piece, sold individually.
Characteristics:
-Diameter of the cable clamp: Ø7mm
-Length total: 1cm
-Diameter cable passage: Ø2,5mm
Reference: usinage_culasse_sur_mesure
Custom machining of a cylinder head.
Reference: 87170000
Ideal in case of breakage, loss or worn thread of your old nut.
Reference: 472434
Ideal for redoing a cylinder in the event of primer, heating or simply to remove micro-scratches that hold the oil.
Reference: 317.0102
Quality stud and reinforced to prevent breakage or wear. Maximum tightening 18nm or 2,04mk / g. In addition to this, you need to know more about it.
Reference: 87175000
Ideal in case of breakage, loss or worn thread of your old nut.
Reference: 87172000
Ideal in case of breakage, loss or worn thread of your old nut.
Reference: 20 6938
For safe power gain at a low price.
Reference: X4 12512042
Reinforced and elongated nuts to better tighten the cylinder head and more precisely. They can withstand much higher tightening torques!
Reference: 19 6313Q
The strongest studs in the range, withstand extreme tightening torques. Amply support 25nm (2.25 mkg)!
Reference: 00002.87
Set of 4 M7 nuts with their 4 washers.
Reference: 87308000
Ideal in case of breakage, loss or worn thread of your old nut.
Reference: rrd-cale-1mm-103-parmakit
1mm wedge in high quality machined aluminum for PARMAKIT large transfer cylinders of PEUGEOT 103, FOX, HONDA WALLAROO. Ideal for laying down long runs to increase your charts!
Reference: 485343
A reinforced stud from CGN, ideal in case of breakage or wear of your old stud. Maximum tightening 16nm or 1.63mk / g.
Reference: 707712
An original stud from PEUGEOT ideal in case of breakage or wear of your old stud. Maximum tightening 16nm or 1,63mk / g.
Reference: ESP.07.116.4
The strongest with MALOSSI, support extreme tightening torques. Support ample 25nm (2,25 mkg)!
Reference: 167916
A set of reinforced and treated P2R cylinder head nuts for quality maintenance of your high engines.