Banner
CGN fuel circuit cut-off to replace the valve or in the event of wear of the vacuum pump.
Very practical and safe, this accessory is too often forgotten or overlooked. It allows you to replace the fuel tap if you don't have one, but not only! When you make carburetor adjustments or even cleaning or disassembly, you are often obliged to remove the hose from the carburetor socket, this accessory allows you to simply unclip! 
Clearly when you want to remove the carburetor, you press on the stainless steel clips of the part and the hose is separated in 2! The 2 ends are also closed! It is therefore on the one hand useless to disconnect the hose, but also useless to close the fuel valve! This hose cutter is of very good quality, blue in color, delivered as presented.
Features :
-Blue color
- Rigid ABS plastic material
-O-ring seal
-Total length 83 mm
-Fixing diameter for hose Ø7 mm 
Reference: 8835
Reinforced cable clamp Ø6mm X L.1,3cm for Ø2,2mm diameter cable.
Reference: 311.0102
POLINI connection for cooling or other filtration
Reference: 0616
A high-end tool to lubricate your brake cables clutch / or other applications.
Reference: 0101.02.031
High Clamp range Ø5,5mm, 8mm length for your cable accelerator, starters ...! Model with incoming screw head.
Reference: 15 1759B
Connection-cooling universal diam 8x1 MALOSSI
Reference: 482746
A universal cable choke control, manual action for efficient operation. Offers a nice aesthetic with its blue color!
Reference: 0182.86
Essential piece to pull 2 cables with another directly from the throttle grip or other. Model with 36mm stroke and cable hole / sheath diameter 6.25mm Black color.
Reference: 15 0651
MALOSSI tee fitting Ø6mm and 8mm. Ideal for adding a lung or other recovery.
Reference: 479341
Quality cable for a replacement at a lower cost.
Reference: 316.0012
Universal starter POLINI different color to choose
Reference: 1628.86
Essential piece to get 2 cables with another directly from the throttle grip or another. Model with 41mm stroke and cable hole / shaft diameter 6,80mm. Red color.
Reference: 2135.86
Essential piece to get 2 cables with another directly from the throttle grip or another. Model with 36mm stroke and cable hole / duct specific 6,80mm diameter with large opening on one side. Brown color.
Reference: 15 0323
MALOSSI T fitting diam. Of your choice. Ideal for adding a recovery lung or other.
Reference: 37 3640
MALOSSI cable clamp Ø5.5 X 9mm. Ideal for a secure attachment.
Reference: CAL01RRD
RRD PERFORMANCES wedge for re-orientation and adaptation of MINARELLI AM6 / DERBI valves / pipe on MOTOBECANE AV10 / MBK 51 engine with POLINI housings.
CGN fuel circuit cut-off to replace the valve or in the event of wear of the vacuum pump.
