Banner
0.50 joint that does not crush to increase your diagrams and therefore with an exact measurement for your squish.
Here is the cylinder shim / base gasket 0.50mm thick. TEKNIX brand, this wedge / seal does not crush in the clamp and allows you to increase your diagrams. With this wedge no need to install an additional seal! Ideal for increasing the diagrams of your cylinder or asking your long strokes. Good quality, the price is only for one seal / shim!
Reference: 06 6055
Super reinforced model to assemble and disassemble your gear without changing it.
Reference: S410210006042
Reinforced compressed 0.35mm seal for your 103, fox, wallaroo in 3 large transfers only.
Reference: 467230
Exhaust gasket round copper large diameter good quality at low price!
Reference: 152018
A good quality exhaust gasket at a low price.
Reference: 2200.38
Premium Viton O-ring for less friction and better sealing of your cylinder head.
Reference: 737841
For safe installation and leak change every reassembly.
Reference: 440825
Gasket reinforced for a longer duration of life.
Reference: 07 1928B
Special 8mm shim for long stroke crankshafts / long connecting rods RRD or MALOSSI on PEUGEOT 103.
Reference: JUN-962
The BARIKIT Ø46mm cylinder head gasket for your 70cc air-cooled kits on PEUGEOT 103.
Reference: 507013
Indispensable for the complete refurbishment of the engine sealing of your PEUGEOT 103.
Reference: rrd-cale-9mm-103
Special 10mm shim for long stroke crankshafts / RRD long connecting rods on PEUGEOT 103.
Reference: rrd-cale-9mm-103-parmakit
Special 9mm shim for large PARMAKIT Ø50mm air or liquid transfer cylinders with long stroke crankshafts / long RRD connecting rods on PEUGEOT 103.
Reference: cale_1mm_103_MALOSSI
Perfect for augmenting your diagrams on 103, fox and wallaroo.
Reference: 209.0009
Ideal for refurbishing your POLINI 70cc air kit on PEUGEOT 103.
Reference: 14022546
Ideal for refurbishment perfect and leak your Ø46mm AIRSAL on 103. Make sure you change your joints at each refitting.
Reference: 508293
0.5 wedge that does not squish to increase your diagrams and therefore with an exact measurement for your squish.
0.50 joint that does not crush to increase your diagrams and therefore with an exact measurement for your squish.
