Reference: 202.1346
Elongated secondary transmission 15/42 POLINI horizontal scooter minarelli (nitro, aerox, ovetto ...)
Long transmission POLINI for NITRO, AEROX, OVETTO, NEO'S, JOG ...
Banner
Malossi SpA is pleased to make available to its customers a new series of primary transmission gears for 50cc scooters.
These new gears are the result of 20 years of experience Malossi in the design and manufacture of gears for scooters racing and road.
The new gears H. t. Q. have been studied and built with straight teeth to minimize losses through friction and stress on the supports. Moreover, our gears increase ratios slightly, allowing to use the power of your scooter and to guarantee a considerable sprint compared to your original scooter.
The transmission is extremely important in a good preparation, if your variator and corrector of couple are has their maximum, your minute level engine revolutions and also that the top speed does not sufficed you! Just change your transmission to operate your bottom to top speed obviously losing some can of acceleration, it will also enable the settings, a different couple, it will accompany the new settings Inverter / spring spurt. We recommend the racing with a housing mounted on bearings and good transmission oil. The primary drive is the one on which the clutch housing is fixed, there are also secondary transmission. The transmission MALOSSI MHR is a real competition of racing room, they have the reputation of being indestructible! Take advantage. Before purchase, we recommend you to observe your primary and secondary transmission to know its teeth and thus judge on which to take. We advocate an area of 100km and running an oil change after 1000/1300 km.
Please note, this transmission teeth are larger than the origin thus the ratio is thereby completely changed despite counting teeth!
Moreover, this transmission is a spur instead of being like the origins or top performance (TPR) in bent teeth. The spur gear enables extra power, much less forcing level transmission, less noise ... W e recommend all the ways a bearing on the transmission case which shall put you less trouble and more performance yet.
There are 2 primary MALOSSI MHR transmissions for engine minarelli scooter
Z (teeth) = 16/40 long Report (longer than the POLINI yet)
Z (teeth) = 13/44 semi long Report (identical to the semi POLINI)
Sélectionez the desired teeth before purchase.
Reference: 202.1346
Long transmission POLINI for NITRO, AEROX, OVETTO, NEO'S, JOG ...
Reference: 057115
Ideal for always more power and accompany a pushed engine configuration.
Reference: 285.0135
Ideal for the refurbishment of your part gear / transmission on casing MINARELLI & PIAGGIO.
Reference: 202.1370
Ideal in combination with a good kit 70cc or 80cc, the extended transmission allows a good gain of speed.
Reference: 283937
Primary transmission for horizontal minarelli (ovetto, nitro, aerox, sr ...). No need for a press as delivered with first 14 tooth sprocket! Ideal for gaining top speed!
Reference: 053715
Ideal for always more power and accompany a pushed engine configuration. Extended secondary transmission with two sizes of toothing choices.
Reference: 67 9966
Longer transmission, ideal for top-of-the-line with good configuration!
Reference: 70350000
Replacement bearing for flywheel side secondary shaft on your scooters!
Reference: PI130491
Ideal for refurbishing your gear/transmission part on PIAGGIO housing.
Reference: 67 7014
Elongated primary transmission, ideal to gain top speed with a good setup on scooter with short horizontal minarelli or KEEWAY!