Reference: PI113681 / 113681 (PIAGGIO)
Washer between bearing and crankshaft Ø15 X 21mm thickness 5mm for PIAGGIO CIAO
Washer between bearing and crankshaft for PIAGGIO CIAO.
Banner
Set of 3 reinforced studs in standard M7 thread for housing and M6 for cylinder head tightening, length 127mm. For casings MALOSSI, POLINI, origin…. From PIAGGIO Ciao, bravo, boss, grillo, yes, superbravo ... Very high quality! The general tightening recommended on a kit with this type of stud is 18 to 20nm! Consider using a torque wrench. This type of studs can fully support more than 25nm in tightening, the casing threads will give way well before them ...
Reference: PI113681 / 113681 (PIAGGIO)
Washer between bearing and crankshaft for PIAGGIO CIAO.
Reference: 6617382
The MALOSSI spy seal for ORIGIN or MALOSSI crankcase on PIAGGIO CIAO.
Reference: 2018473
Pipe for passage on flexible assembly.
Reference: 513030
Very good quality black screws with a wide choice of sizes for many applications!
Reference: RONDELLES_5717514
Rings between bearing and vilebrequin for PIAGGIO CIAO.
Reference: 215.0362
The 13mm intake pipe for your POLINI housings on PIAGGIO CIAO.
Reference: 34120100
The replacement 15mm intake pipe for your POLINI crankcases on PIAGGIO CIAO.
Reference: 285.0122
POLINI spy joint for crankcase ORIGIN on PIAGGIO CIAO.
Reference: 19 4329
Reference: 162574
Black screw of very good quality with a wide choice of sizes for many applications!
Reference: 02 6265B
Pipe for fitting a DELLORTO SHA 13 on MALOSSI CIAO housings.
Reference: 209.0352
The spare joint pack for your POLINI housings on PIAGGIO CIAO!
Reference: 89770000
Fixing screw kit for PIAGGIO CIAO 50 engine.
Reference: 1618194
MHR 21mm carburetion kit flexible mounting on CIAO with MALOSSI housings.