Reference: 516867
Inlet pipe DOPPLER OPEN 3D Ø20mm (PHBG) flexible with sleeve for Peugeot 103
A shorter pipe for a better venturi effect. It will be perfect with a 19 to 21mm carburettor.
Banner
Polini intake pipe for Peugeot 103 sp, mv, mvl, lm… cannot be mounted on spx, rcx or clip! Aesthetic level is the must, top finish with its small POLINI logo on the side. For carburettors from 17.5 to 21mm, for the best take a Ø19mm DELLORTO PHBG. Fixing diameter for 24mm diameter carburetor.
Very high quality, we simply regret that it is not blasted internally. Pipe outlet 26 by 23mm.
Reference: 516867
A shorter pipe for a better venturi effect. It will be perfect with a 19 to 21mm carburettor.
Reference: 1399
Ideal in case of breakage or wear of your old part.
Reference: 1402
An intake pipe with a good finish that will allow you to mount your carburetor Ø14 to 16mm while gaining power.
Reference: 2017588
Special pipe for peugeot 103 vogue, ideal in combination of a carburetor of 15mm SHA and a valve sport!
Reference: 1403
A pipe which will be perfect accompanied by a carburettor PHBG 19 to 21mm. This pipe is blasted with a good finish to avoid the rebound of gases.
Reference: 1400
An amazing pipe with a very good finish that will agree very well with a carburetor 18 to 21mm.
Reference: 496075
Ideal in case of breakage or wear your old room.
Reference: 215.0226
Intake pipe ideal for fitting SHA 15 or 16mm carburettors.
Reference: 02 6487B
The best to accompany a 15 or 16mm SHA carburetor on your 103!
Reference: 365641
A shorter pipe for better venturi effect. This pipe is the highest end of the market. It will be perfect with a carburetor 19 to 21mm.
Reference: 144.270.001
Flexible polini pipe 21mm for mini-moto and cross 2T POLINI, or mounting on POLINI crankcases with PEUGEOT 103 and MBK 51 supports!
Reference: CAL02RRD
RRD PERFORMANCES wedge for re-orientation and adaptation of MINARELLI AM6 / DERBI valves / pipe on PEUGEOT 103 engine with POLINI housings, with built-in brackets.
Reference: 02 6489B
A pipe specially designed for flexible assemblies. This pipe was specially created for the competition. It is therefore mounted with a flexible PHBG carburetor from 15 to 21mm.
Reference: 02 6488B
A pipe that mounts very well with a PHBG from 17.5 to 21mm. This pipe is corrected and revised for better distribution.
Reference: PIP07
Intake pipe for carburetor in flexible assembly from 15 to 21mm.